Frictional properties of a surface covered with soft metal surface film. 3rd report. Approximate equation representing frictional coefficient.
نویسندگان
چکیده
منابع مشابه
Frictional effects near a metal surface.
When a classical master equation (CME) is used to describe the nonadiabatic dynamics of a molecule at metal surfaces, we show that in the regime of reasonably strong molecule-metal couplings, the CME can be reduced to a Fokker-Planck equation with an explicit form of electronic friction. For a single metal substrate at thermal equilibrium, the electronic friction and random force satisfy the fl...
متن کاملStudy of the Frictional Surface Damage Using Acoustic Emission Method
In this study, the change at rubbing surfaces has been investigated experimentally using an acoustic emission signal monitoring system. A steel ring is slipped on the surface of a metallic sheet to simulate frictional conditions. The mechanical disturbances caused by the movement of the ring produce stress waves propagating along the sheet surface. The out of plane displacement of the sheet su...
متن کاملFrictional properties of confined polymers.
We present molecular dynamics friction calculations for confined hydrocarbon solids with molecular lengths from 20 to 1400 carbon atoms. Two cases are considered: a) polymer sliding against a hard substrate, and b) polymer sliding on polymer. In the first setup the shear stresses are relatively independent of molecular length. For polymer sliding on polymer the friction is significantly larger,...
متن کاملSystem identification of a beam with frictional contact
The nonlinear system becomes an area with numerous investigations over the past decades. The conventional modal analysis could not be applied on nonlinear continuous system which makes it impossible to construct the reduced order models and obtain system response based on limited number of measurement points. Nonlinear normal modes provide a useful tool for extending modal analysis to nonlinea...
متن کاملFrictional behavior and surface failure of acrylic denture teeth.
The water characteristics of acrylic denture teeth were investigated under single- and double-pass sliding. The response of acrylic teeth to sliding was that of a relatively ductile material. The wear characteristics were affected similarly by environments of water and saliva. The "enamel" surfaces showed more resistance to penetration and were less susceptible to surface damage than the "denti...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1988
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.54.743