Friction Weldability of a High Nb Containing TiAl Alloy
نویسندگان
چکیده
منابع مشابه
Creep of nearly lamellar TiAl alloy containing W
Effects of W on the creep resistance of two nearly fully lamellar TiAl alloys with 1.0 and 2.0 at.% W have been investigated. In the low stress regime (LS) a nearly quadratic (1:5 < n < 2) creep behavior was observed. It is found that the addition of W can improve the creep resistance; however, the addition of excess W can result in the formation of b phase, which produces an adverse effect on ...
متن کاملMicrostructural Characterization of Melt Extracted High-Nb-Containing TiAl-Based Fiber
The microstructure of melt extracted Ti-44Al-8Nb-0.2W-0.2B-1.5Si fiber were investigated. When the rotation speed increased from 2000 to 2600 r/min, the appearance of the wire was uniform with no Rayleigh-wave default. The structure was mainly composed of fine α₂ (α) phase dendritic crystal and a second phase between dendrite arms and grain boundaries. The precipitated second phases were confir...
متن کاملBoron segregation in a (Fe, V, B) TiAl based alloy
Primary boron containing dispersoids grown from the melt in a Ti-45.5at.%Al-1.6at.%Fel.lat.%V-0.7at.%B alloy, and then annealed at 1473K, have been investigated using optical microscopy, conventional transmission electron microscopy (CTEM) and analytical electron microscopy. The dispersoid morphology is in the form of high aspect ratio plates, hundreds of microns across and cross-sectional widt...
متن کاملConditions for CET in a gamma TiAl alloy
The solidification of gamma TiAl alloys is of interest to the aerospace and automotive industries. A gamma TiAl multicomponent alloy: Ti–45.5Al–4.7Nb–0.2C–0.2B (at. %) has been the focus of a study to investigate the solidification conditions that led to a Columnar to Equiaxed Transition (CET) in a directional solidification experiment where traditional Bridgman solidification was combined in s...
متن کاملModeling of TiAl Alloy Grating by Investment Casting
The investment casting of TiAl alloys has become the most promising cost-effective technique for manufacturing TiAl components. This study aimed to investigate a series of problems associated with the investment casting of TiAl alloys. The mold filling and solidification of this casting model were numerically simulated using ProCAST. Shrinkage porosity was quantitatively predicted by a built-in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2019
ISSN: 1996-1944
DOI: 10.3390/ma12213556