FRICTION TECHNIQUE FOR DETERMINING FORMING LIMIT CURVES
نویسندگان
چکیده
منابع مشابه
Effect of different yield functions on computations of forming limit curves for aluminum alloy sheets
In this article, the effect of different yield functions on prediction of forming limit curve (FLC) for aluminum sheet is studied. Due to importance of FLC in sheet metal forming, concentration on effective parameters must be considered exactly in order to have better theoretical prediction comparing experimental results. Yield function is one of the factors which are improved by adding new coe...
متن کاملA New Approach for Determining the Friction Law in Metal Forming
The most popular friction law in metal forming applications is Tresca’s law which postulates that the friction stress is equal to a portion of the local shear yield stress. The friction factor involved in this law should be found from experiment. A typical test for this purpose is the ring compression test. The test must be supplemented with a theoretical analysis. The latter is often based on ...
متن کاملMultiscale Friction Modeling for Sheet Metal Forming
The most often used friction model for sheet metal forming simulations is the relative simple Coulomb friction model. This paper presents a more advanced friction model for large scale forming simulations based on the surface change on the micro-scale. The surface texture of a material changes when two surfaces are in contact under a normal load. This is caused by flattening due to combined nor...
متن کاملFriction generated limit cycles
This paper treats limit cycles caused by friction. The goal has been to explain phenomena that have been observed experimentally in mechatronic systems. Experiments have shown that oscillations of qualitatively different types can be obtained simply by changing controller specifications. Stiction is important in some cases but not in others. Necessary conditions for limit cycle are given for th...
متن کاملPrediction of forming limit curves (FLD, MSFLD and FLSD) and necking time for SS304L sheet using finite element method and ductile fracture criteria
Forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. In this research, forming limit diagram (FLD) of SS304L sheet was obtained by ABAQUSfinite element software. In practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. Forming limit di...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: AL-Rafdain Engineering Journal (AREJ)
سال: 2006
ISSN: 2220-1270
DOI: 10.33899/rengj.2006.45352