Friction Stir Welding of Fine Grained Al Alloys Produced by Egual Channel Angular Pressing and Accumulative Roll-Bonding

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Friction stir welding of accumulative roll bonded single phase brass

Single phase brass strips with 2 mm thickness were severely deformed through 1 and 3 cycles of accumulative roll bonding process (ARB). ARB process effectively increased the hardness, yield strength, and the ultimate strength of the processed materials. The hardness of processed material increased from 95 HV in annealed material to 225 HV in 3 cycle ARBed material, and the yielding and ultimate...

متن کامل

Friction stir welding of accumulative roll bonded single phase brass

Single phase brass strips with 2 mm thickness were severely deformed through 1 and 3 cycles of accumulative roll bonding process (ARB). ARB process effectively increased the hardness, yield strength, and the ultimate strength of the processed materials. The hardness of processed material increased from 95 HV in annealed material to 225 HV in 3 cycle ARBed material, and the yielding and ultimate...

متن کامل

Ultra-fine Grained Bulk Steel Produced by Accumulative Roll-bonding (arb) Process

Much attention has been directed recently to ultra-grain refining of metallic materials, where the grain size is reduced to less than 1 mm. It is expected that submicrometer grained structure would result in high strength and toughness at ambient temperature [1] as well as high strain rate or low temperature superplasticity at elevated temperatures [2,3]. It has been reported recently that ultr...

متن کامل

INVESTIGATION OF TRIBOLOGICAL CHARACTERISTICS OF AL/NANO SiO2NANOCOMPOSITES PRODUCED BY ACCUMULATIVE ROLL BONDING (ARB) PROCESS

Accumulative roll-bonding process (ARB) is an important severe plastic deformation technique for production of the ultrafine grained, nanostructured and nanocomposite materials in the form of plates and sheets. In the present work, this process used for manufacturing Al/SiO 2 nanocomposites by using Aluminum 1050 alloy sheets and nano sized SiO 2 particles, at ambient temperature. After 8 cycle...

متن کامل

High Temperature Deformation of Twin-Roll Cast Al-Mn-Based Alloys after Equal Channel Angular Pressing

Twin roll cast Al-Mn- and Al-Mn-Zr-based alloys were subjected to four passes of equal channel angular pressing. The resulting grain size of 400 nm contributes to a significant strengthening at room temperature. This microstructure is not fully stable at elevated temperatures and recrystallization and vast grain growth occur at temperatures between 350 and 450 °C. The onset of these microstruct...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Japan Welding Society

سال: 2005

ISSN: 0021-4787,1883-7204

DOI: 10.2207/qjjws1943.74.109