Friction Performance of Al-10%SiCp Reinforced Metal Matrix Composites Using Taguchi Method
نویسندگان
چکیده
منابع مشابه
Casting of SiC Reinforced Metal Matrix Composites
Composites based on two aluminium alloys (A536 and 6061) reinforced with 10% or 20% volume fraction of SiC particles were produced by gravity casting and a novel two-step mixing method was applied successfully to improve the wettability and distribution of the particles. The SiC particles were observed to be located predominantly in the interdendrit ic regions, and a thermal lag model is propos...
متن کاملCompoforging of Al-Si Metal Matrix Composites Reinforced with -SiC: An Alternative Technique
This paper reports the -SiC particles surface modification by copper Electroless Plating (EP), as well as a morphological characterization of Al-Si reinforced composite obtained with such modified particles and consolidated by compoforging. The -SiC particles were obtained by thermal degradation of organic waste. The compoforging technique is a hybrid between the compocasting process and semi-s...
متن کاملFracture Analysis of Particulate Reinforced Metal Matrix Composites
A fracture analysis of highly loaded particulate reinforced composites was performed using laser moire interferometry to measure the displacements within the plastic zone at the tip of an advancing crack. Ten castings were made of five different particulate reinforcement-aluminum alloy combinations. Each casting included net-shape specimens which were used for the evaluation of fracture toughne...
متن کاملPrediction of the Thermomechanical Behavior ofParticle-Reinforced Metal Matrix Composites
The objective of this paper was to predict the thermomechanical behavior of 2080 aluminum alloy reinforced with SiC particles using the Mori–Tanaka theory combined with the finite element method. The influences of particle volume fraction, stiffness, aspect ratio and orientation were examined in terms of effective Young’s modulus, Poisson’s ratio and coefficient of thermal expansion (CTE) of th...
متن کاملWear of ceramic particle-reinforced metal-matrix composites
Wear experiments have shown that when the applied normal stress exceeds a critical value, a transition occurs from the regime of mild wear to that of adhesive wear. As a result, the wear rate of particle-reinforced aluminium composites increases by a hundred-fold. Based on dislocation and delamination theories, a criterion is proposed for determining the critical transition load, and a quantita...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISRN Tribology
سال: 2013
ISSN: 2090-889X
DOI: 10.5402/2013/386861