Friction coefficient in mixed lubrication: A simplified analytical approach for highly loaded non-conformal contacts
نویسندگان
چکیده
منابع مشابه
Hydrodynamic and Elastohydrodynamic Lubrication
Contents 1. Introduction 2. Stress-induced lubricant degradation 3. Basic equations governing the fluid elastohydrodynamic lubrication (EHL) of line and point contacts 3.1. Equations of fluid motion 3.2. Contact surface displacements in line and point lubricated contacts 4. Steady isothermal EHL problems for lightly loaded non-conformal line contacts 5. Steady isothermal EHL problems for heavil...
متن کاملAnalysis of Mixed Lubrication Effects in Simulated Gear Tooth Contacts
The paper presents results obtained using a transient analysis technique for point contact elastohydrodynamic lubrication (EHL) problems based on a formulation that couples the elastic and hydrodynamic equations. Results are presented for transverse ground surfaces in elliptical point contact that show severe film thinning and asperity contact at the transverse limits of the contact area. This ...
متن کاملFriction models for sliding dry, boundary and mixed lubricated contacts
Friction, lubrication, and wear have a strong influence on the performance and behavior of mechanical systems. This paper deals with different friction models for sliding contacts running under different conditions. The models presented are suited to different situations, depending on the type of contact, running conditions, and the behavior of interest. The models will be discussed from simula...
متن کاملFriction Force for Boundary Lubrication
A thermodynamic model describing the phase transition of first order between structure states of lubricant material in the boundary friction regime is proposed. It is shown that lubricant melts with temperature increase or at shear of rubbing surfaces if the elastic strain (stress) exceeds the critical value. The phase diagram with domains of dry and sliding friction is constructed. The depende...
متن کاملFriction and Lubrication
FRICTION AND LUBRICATION in sheet metal forming are influenced by such parameters as material properties, surface finish, temperature, sliding velocity, contact pressure, and lubricant characteristics. The parameters that affect friction and lubrication are schematically shown in Fig. 7.1. Depending on these parameters, the performance of a lubricant and the coefficient of friction (COF) vary. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2017
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814017706266