Friction and Wear of Sintered Alumina at High Temperature.
نویسندگان
چکیده
منابع مشابه
Deformation and Grain Growth of Low-Temperature-Sintered High-Purity Alumina
9 = 0.6 I / s ' 7 = 6.0 0 7 = 2 4 i ti 3 = 6 0 Through close control over green-state powder processing, pure alumina ceramics of 0.5-pm grain size were obtained by sintering at 1250°C. The static grain growth of this material was modest at temperatures below 1300°C. However, dynamic grain growth occurred rapidly during superplastic deformation. Therefore, although the ultrafine-grained alumina...
متن کاملWear and Friction Analysis of Sintered Metal Powder Self Lubricating Bush Bearing
Abstract—Powder metallurgy (P/M) is the only economic way to produce porous parts/products. P/M can produce near net shape parts hence reduces wastage of raw material and energy, avoids various machining operations. The most vital use of P/M is in production of metallic filters and self lubricating bush bearings and siding surfaces. The porosity of the part can be controlled by varying compacti...
متن کاملMicro-Structures and High-Temperature Friction-Wear Performances of Laser Cladded Cr–Ni Coatings
Cr-Ni coatings with the mass ratios of 17% Cr-83% Ni, 20% Cr-80% Ni and 24% Cr-76% Ni were fabricated on H13 hot work mould steel using a laser cladding (LC). The surface-interface morphologies, chemical elements, surface roughness and phase composition of the obtained Cr-Ni coatings were analysed using a scanning electron microscope (SEM), energy disperse spectroscopy (EDS), atomic force micro...
متن کاملPreparation and evaluation of geopolymer composites containing alumina particles at ambient temperature and after heating
In this research, geopolymer composites were prepared using metakaolin along with silica fume and potassium hydroxide as alkaline activators and alumina particles. The effect of alumina particle size to achieve castable microstructure and their mechanical properties were investigated. Different Si:Al mole ratio (1.5, 2, 2.5 and 3) and K:Si mole ratio (0.20, 0.25, 0.33) were formulated and the s...
متن کاملMicroseparation and stripe wear in alumina-on-alumina hip implants.
The combination of materials that still has highest wear resistance for total hip replacement is ceramic-on-ceramic. However, brittleness is a major concern for ceramics: in vivo and in vitro studies on ceramic hip prostheses correlate microseparation with hip noise, ceramic wear, or ceramic liner damage. Ceramic microseparation can lead to edge load, ceramic head wear, and squeaking. The aim o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. 3, Vibration, control engineering, engineering for industry
سال: 1992
ISSN: 0914-8825
DOI: 10.1299/jsmec1988.35.660