Friction and Wear of Graphite-Ni Composite.
نویسندگان
چکیده
منابع مشابه
Study of the wear and friction behavior of immiscible as cast - Al - Sn / Graphite composite
In this paper we investigate the tribological properties of AlSn-based alloy with different amount of graphite at different normal loads and sliding speed. A modified impeller mixing coupled with chill casting technique was used for the preparation of immiscible alloys. In this paper Al-Sn binary alloys was chosen for this study. This binary system shows the miscibility gap at different concent...
متن کاملFabrication of Al/Graphite/Al2O3 Surface Hybrid Nano Composite by Friction Stir Processing and Investigating The Wear and Microstructural Properties of The Composite
Friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite reinforced with nano sized Al2O3 and micro sized graphite particles. A mixture of Al2O3 and graphite particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083 aluminum plate of 10 mm thick. Packed groove was subjected to friction stir processing in order to im...
متن کاملfabrication of al/graphite/al2o3 surface hybrid nano composite by friction stir processing and investigating the wear and microstructural properties of the composite
friction stir processing was applied for fabricating an aluminum alloy based hybrid nano composite reinforced with nano sized al2o3 and micro sized graphite particles. a mixture of al2o3 and graphite particles was packed into a groove with 1 mm width and 4.5 mm depth, which had been cut in 5083 aluminum plate of 10 mm thick. packed groove was subjected to friction stir processing in order to im...
متن کاملInfluence of electrical discharge machining on sliding friction and wear of WC–Ni cemented carbide
Tribological characteristics of fine-grained WC–8 wt%Ni with different surface finishing conditions corresponding to sequential wire electrical discharge machining (wire-EDM) or grinding were investigated by performing dry reciprocating sliding experiments on TE77 pin-on-plate equipment with WC–6 wt%Co as mating material. Surface finishes and wear surfaces were characterized using surface topog...
متن کاملMicro-Structures and High-Temperature Friction-Wear Performances of Laser Cladded Cr–Ni Coatings
Cr-Ni coatings with the mass ratios of 17% Cr-83% Ni, 20% Cr-80% Ni and 24% Cr-76% Ni were fabricated on H13 hot work mould steel using a laser cladding (LC). The surface-interface morphologies, chemical elements, surface roughness and phase composition of the obtained Cr-Ni coatings were analysed using a scanning electron microscope (SEM), energy disperse spectroscopy (EDS), atomic force micro...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1999
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.46.967