Friction and Wear Mechanism of Zirconia in Unlubricated Sliding Contact
نویسندگان
چکیده
منابع مشابه
A Triboscopic Investigation of the Wear and Friction of MoS2 in a Reciprocating Sliding Contact
Reciprocating sliding tests with ball-on-flat geometry were performed on a duplex coating at low speeds in moist air (RH=60%). The coating, 55 nm MoS2 on 35 nm of TiN, was deposited by ion-beam assisted deposition onto a steel substrate. Friction coefficient (μ) and electrical contact resistance (Rc) measurements were recorded at ~2μm intervals along the track; these spatially resolved measurem...
متن کاملReciprocating sliding friction and wear behavior of electrical discharge machined zirconia-based composites against WC–Co cemented carbide
a Department of Mechanical Construction and Production, Ghent University (UGent), IR04, Sint-Pietersnieuwstraat 41, B-9000 Gent, Belgium b Department of Metallurgy and Materials Engineering, Catholic University Leuven (K.U. Leuven), MTM, Kasteelpark Arenberg 44 (bus 2450), B-3001 Leuven, Belgium c Department of Mechanical Engineering, Catholic University Leuven (K.U. Leuven), PMA, Celestijnenla...
متن کاملAnalysis of Wear Phenomena in Sliding Contact Surfaces
A general approach to numerically simulating wear in rolling and sliding contacts is presented in this thesis. A simulation scheme is developed that calculates the wear at a detailed level. The removal of material follows Archard‟s wear law, which states that the reduction of volume is linearly proportional to the sliding distance, the normal load and the wear coefficient Careful attention is p...
متن کاملSliding Friction Contact Stiffness Model of Involute Arc Cylindrical Gear Based on Fractal Theory
Gear’s normal contact stiffness played an important role in the mechanical equipment. In this paper, the M-B fractal model is modified and the contact surface coefficient is put forward to set up the fractal model, considering the influence of friction, which could be used to calculate accurately the involute arc cylindrical gears’ normal contact stiffness based on the fractal theory and Hertz ...
متن کاملSYNTHESIS OF FUNCTIONALLY GRADED Al LM25/ZIRCONIA COMPOSITE AND ITS SLIDING WEAR CHARACTERIZATION USING RESPONSE SURFACE METHODOLOGY
Functionally graded aluminium/zirconia metal matrix composite was fabricated using stir casting technique followed by horizontal centrifugal casting process and a hollow cylindrical functionally graded composite (150 x 150 x 16 mm) was obtained with centrifuging speed of 1200 rpm. The microstructural evaluation and hardness test was carried out on the outer and inner surface of the functionally...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 1996
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.104.659