Friction and lubrication mechanism of a new type of anti-magnetic bearing Ti60 titanium alloy material
نویسندگان
چکیده
منابع مشابه
the investigation of the relationship between type a and type b personalities and quality of translation
چکیده ندارد.
Magnetic fluid lubrication of porous pivoted slider bearing with slip and squeeze velocity
In this paper the problem on “Magnetic fluid lubrication of porous-pivoted slider bearing with slip velocity by N Ahmad et.al.[7]” has been recapitulated using Jenkin’s model [4] with the additional effect of squeeze velocity of the above plate. It is found that while discussing the above problem, [7] has stated but ignored the term , where +, in their study (Refer equation(2.2)). This paper re...
متن کاملa new algorithm and software of individual life insurance and annuity computation
چکیده ندارد.
15 صفحه اولThe Effect of Tool Geometry on Material Flow Behavior of Friction Stir Welding of Titanium Alloy
Article history: Received 1.11.2012 Received in revised form 10.12.2012 Accepted 10.12.2012 Based on the RNG k-ε model, the finite volume model of friction stir welding of Ti6Al4V alloy is established by ANSYS FLUENT software. The effect of rotational tool geometry on titanium alloy flow behaviour is exhibited. The results of numerical simulation show that the flow direction of material near th...
متن کاملFriction stir welding of dissimilar joint of aluminum alloy 5083 and commercially pure titanium
In this study, commercially pure titanium and aluminum alloy 5083 in connection rotational speed of 1120 rpm and a feed rate of 50 mm per minute for butt welding by friction stir welding has been successfully completed. Micro-structure, hardness and tensile test was conducted on the connection. Welding area is a composite of aluminum and titanium particles that the particles plays an important ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Results in Physics
سال: 2019
ISSN: 2211-3797
DOI: 10.1016/j.rinp.2018.11.058