منابع مشابه
Fretting wear in self-piercing riveted aluminium alloy sheet
Fretting wear in aluminium alloy AA5754 joined by self-pierce riveting (SPR), a relatively new fastening technique increasingly used in vehicle structures, has been investigated in this paper. Surface damages have been induced when a joint experienced a sinusoidal cyclic tension-tension load. Various degradation zones have been characterised in the contact surfaces between the aluminium sheets,...
متن کاملStrain-induced Texture Development in the Magnesium Alloy Az31
Magnesium alloys are receiving increasing attention as a structural material in vehicles to reduce weight and increase fuel economy. Understanding the formability of lightweight alloys is one key to their successful introduction in vehicles. We present results of X-Ray diffraction and electron back-scatter diffraction texture measurements in as-cast and uniaxially compressed AZ31 for a variety ...
متن کاملAnodizing of Magnesium Alloy Az31 by Alkaline Solution
-Anodizing of AZ 31 Mg alloy was investigate in 3M KOH solution for 10, 20 and 30min. at constant voltage of 5V. Atomic force microscope (AFM) used to investigate the roughness of anodic film formed on the surface while the scanning electron microscope (SEM) was used to determine the morphology of the anodic film, it was found that the roughness of the anodic film is mainly depend on the anodiz...
متن کاملCorrosion Behavior of the Friction Stir Welded AZ31 Magnesium Alloy.
* IDMEC, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049-001 Lisboa, Portugal ** DEQ/ICEMS, Instituto Superior Técnico, Universidade de Lisboa, Av. Rovisco Pais, 1049001 Lisboa, Portugal. *** Department of Engineering Design and Production, School of Engineering, Aalto University, P.O. Box 1420, FI-00076 Aalto, Finland **** Faculdade de Engenharia da universidade do P...
متن کاملTowards Superplastic Forming of Az31 Magnesium Alloy with Controlled Microstructure
A recent study on post-superplastic forming properties has shown that heating time prior to testing has a major effect on the post-forming properties of superplastically-formed AZ31 Magnesium alloy sheets. To this point, there has been very little examination into the effects of pre-heating or annealing on superplastic forming. In this work, these effects are examined using AZ31 Mg alloy sample...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the JSME (in Japanese)
سال: 2016
ISSN: 2187-9761
DOI: 10.1299/transjsme.16-00275