منابع مشابه
Magnetic Anisotropy in Silicon Iron
The first anisotropy constant for Fel-%Si, is determined by torque measurements, for x up to 10 atomic per cent, in the temperature range 21-300 OK. The values, as extrapolated to 0 OK, vary linearly with silicon content. Using the expressions obtained by Keffer and Oguchi it is shown that K1 at 0 OK should vary as { 1 (a + 2) x ) where a is the ratio of dipole contribution to the total value o...
متن کاملMachining Free-Form Surfaces
This paper presents an analytical method for planning an efficient tool-path in machining free-form surfaces on 3-axis milling machines. This new approach uses a nonconstant offset of the previous tool-path, which guarantees the cutter moving in an unmachined area of the part surface and without redundant machining. The method comprises three steps: (1) the calculation of the tool-path interval...
متن کاملLarge-Scale and Defect-Free Silicon Metamaterials with Magnetic Response
All-dielectric metamaterials offer a potential low-loss alternative to plasmonic metamaterials at optical frequencies. Here, we experimentally demonstrate a silicon based large-scale magnetic metamaterial, which is fabricated with standard photolithography and conventional reactive ion etching process. The periodically arrayed silicon sub-wavelength structures possess electric and magnetic resp...
متن کاملLarge enhancements of magnetic anisotropy in oxide-free iron nanoparticles
Magnetic characterization of spherical, oxide-free, bcc iron nanoparticles synthesized with b-diketone surfactants has been performed. The results of this characterization, which included particles with diameters ranging between 2 and 5 nm show that the nanoparticles have an average anisotropy of 1.9 1070.3 10 J/m, which is more than an order of magnitude greater than the magnetocrystalline ani...
متن کاملCutting Mechanism of Sulfurized Free-Machining Steel
In order to improve efficiency of cutting process in production industry, development of new steel which has good machinablity is desired. The work material which has good surface roughness, easy breakable chip and small tool wear as the good machinablity is expected. And the free-machining steel was developed owning to adding elements which could make the machinablity better. Of all others, le...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: DENKI-SEIKO[ELECTRIC FURNACE STEEL]
سال: 1971
ISSN: 1883-4558,0011-8389
DOI: 10.4262/denkiseiko.42.136