Fracture Toughness Evaluation of a Ni2MnGa Alloy Through Micro Indentation Under Magneto-Mechanical Loading

Nanoindentation and micro-mechanical fracture toughness of electrodeposited nanocrystalline Ni–W alloy films

Effect of loading rate on the plane stress fracture toughness properties of an aluminum alloy

The effect of loading rate on the plane stress fracture toughness properties of a 3.2-mm thick 2219-T87 aluminum alloy plate was investigated with center-cracked panels. Plane-stress J-resistance curves were generated at a constant displacement rate of 10-6 and 5.7 m s-l. Dynamic fracture testing was performed with a coupled pressure plates technique. Fracture initiation and propagation toughne...

fracture toughness evaluation for brittle polymers under combined tensile-shear loading

fast fracture is one of the major failure modes in brittle polymers. generally, crack growth in these polymers may occur under combined tensile-shear loading. however, the fracture test data reported previously for some dental restorative resins can not be predicted by using the available fracture criteria.in this paper, a modified fracture criterion is used for estimating the fracture load for...

Study of Variation of the J-integral and the Fracture Toughness in Blunt V-notches under Mode I Loading

Fracture assessment of U- and V-notches is important in mechanical engineering. One can use the J-integral as fracture parameter in order to predict the critical fracture load in notches. The critical value of the J-integral in cracks is a function of the material properties. In notches, however, the material properties as well as the notch dimensions affect this critical value (named fracture ...

Fracture toughness measurement of dental ceramics using the indentation fracture method with different formulas.

This study examined fracture toughness (KIC) measurements obtained using the indentation fracture (IF) method with a view to improving their reliability. The KIC values of five dental ceramics were measured using the IF method with five different formulas, and the single-edge precracked beam (SEPB) method was used as a control. The elastic moduli of the dental ceramics were evaluated by dynamic...