Fracture strength and toughness of ultra high strength TRIP aided steels
نویسندگان
چکیده
منابع مشابه
High-Strength Bainitic Steels
With careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thin films of stable retained austenite have exhibited impressive combinations of strength and toughness in highsilicon bainitic steels. The silicon suppresses the precipitation of brittle cementite leading to an improvement in toughness. The essential principles governing the optimisatio...
متن کاملhigh-strength bainitic steels
with careful design, mixed microstructures consisting of fine plates of upper bainitic ferrite separated by thinfilms of stable retained austenite have exhibited impressive combinations of strength and toughness in highsiliconbainitic steels. the silicon suppresses the precipitation of brittle cementite leading to an improvement intoughness. the essential principles governing the optimisation o...
متن کاملCarbide Structure and Fracture Toughness of High Speed Tool Steels
In the present study, M2 high speed steels were fabricated by using electro-slag rapid remelting process. Carbide structure was analysed and the fracture toughness and hardness were also measured after austenitization treatment at 1190 and 1210C followed by tempering treatment at 535C for billets with various diameters from 16 to 60 mm. Electro-slag rapid remelting (ESRR) process is an advanced...
متن کاملSTRENGTH AND FRACTURE TOUGHNESS OF WHISKER REINFORCED DENTAL RESIN-BASED COMPOSITES
Enhancing the properties of dental resin composites is of interest to researchers. The objective of the present investigation was to improve the strength and fracture toughness of dental composites via addition of silicon carbide whiskers and substitution of commonly used filler materials with stabilized zirconia ceramic powder. It was also intended to study the effect of powder- to- whisker ra...
متن کاملUltrahigh Charpy impact toughness (~450J) achieved in high strength ferrite/martensite laminated steels
Strength and toughness are a couple of paradox as similar as strength-ductility trade-off in homogenous materials, body-centered-cubic steels in particular. Here we report a simple way to get ultrahigh toughness without sacrificing strength. By simple alloying design and hot rolling the 5Mn3Al steels in ferrite/austenite dual phase temperature region, we obtain a series of ferrite/martensite la...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science and Technology
سال: 2009
ISSN: 0267-0836,1743-2847
DOI: 10.1179/174328409x453307