Fracture Energy of Foamed Concrete Based on Three-Point Bending Test on Notched Beams
نویسندگان
چکیده
منابع مشابه
Determining Fracture Toughness of Bone with Double Notched Beams in Four-Point Bending
Studies of bone have determined multiple toughening mechanisms slowing the propagation of a crack. These toughening mechanisms contribute to the fracture toughness of bone in life, making their activities of clinical interest. The primary standard methods for measuring bone fracture toughness use a single-notched compact type specimen (CT) or single-notched bending specimens in four-point (SN4P...
متن کاملMixed Mode Fracture in Reinforced Concrete with Low Volume Fraction of Steel Fibers
An investigation into the mixed mode fracture of steel fiber reinforced concrete (SFRC)beams with one percent volume fraction of steel fiber is presented. A series of notched beams withdifferent notch depths and locations are tested under three-point bending. The test results for apparentfracture toughness, crack trajectories, and fracture energy are presented. The crack paths for SFRCand plain...
متن کاملPart A- Experimental: Experimental Analysis of Crack Propagation in Pre-stressed Concrete Sleepers by Fracture Mechanics
This study investigates propagation of mode I crack in B70 pre-stressed concrete sleepers by fracture mechanics approach. A new experimental analysis is done for notched B70 pre-stressed concrete sleepers with Replica test and image analysis. A scanning electron microscope test (SEM) and an image analysis are applied for the Replica test in order to determine crack length and crack mouth openin...
متن کاملEffect of Incorporating Foamed Glass on the Flexural Behaviour of Reinforced Concrete Beams
The flexural behaviour of concrete containing Foamed glass as partial replacement of coarse aggregate is investigated. The coarse aggregate was replaced with 0%, 25%, 50%, 75% and 100% Foamed glass. All other constituents were maintained the same. Reinforced concrete beams were cast using 2 bars of 8mm in diameter in the tensile zone. The density and compressive strength of concrete decreased a...
متن کاملMODIFICATION INFLUENCE OF MISCHMETAL ON FRACTOGRAPHY FRACTURE OF G17CrMo5-5 CAST STEEL SAMPLES AFTER THE THREE-POINT BENDING TEST
J. Kasińska, Faculty of Mechatronics and Machine Design, Kielce University of Technology, Kielce, Poland The article presents the analysis of fracture surfaces after the three-point bending test at a temperature range from + 20 °C to 80 °C. The author shows a beneficial effect of mischmetal on the cracking mechanism and on the character of fractures. It has been shown that the width of the duct...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2015
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2015.06.157