Fracture analysis of U71Mn rail flash-butt welding joint
نویسندگان
چکیده
منابع مشابه
CFD Modelling of Friction Stir Welding of Aluminum to Steel butt joint
In this article effects of friction stir welding (FSW) tool rotational and traverse speeds were studied on heat generation and temperature distribution in welding zone of AA1100 aluminum alloy and A441 AISI joint. Computational fluid dynamics method was used to simulate the process with commercial CFD Fluent 6.4 package. To enhance the accuracy of simulation in this Study, the welding line that...
متن کاملHomopolar Pulse Welding of Rail
The homopolar pulse welding process uses a single unidirectional, high current electrical pulse from a homopolar generator to heat the interface between two workpieces in solid contact. When the interface reaches an optimum temperature, forging pressure is applied, and the workpieces coalesce without melting and without use of either a flux or a filler. The weld is completed in from 1 to 2 s. B...
متن کاملA Vision-Aided 3D Path Teaching Method before Narrow Butt Joint Welding
For better welding quality, accurate path teaching for actuators must be achieved before welding. Due to machining errors, assembly errors, deformations, etc., the actual groove position may be different from the predetermined path. Therefore, it is significant to recognize the actual groove position using machine vision methods and perform an accurate path teaching process. However, during the...
متن کاملCorrection of Butt-welding Induced Distortions by Laser Forming
Welding-induced distortion is an intrinsic phenomenon arising due to the thermally induced strain distributions in the weld and surrounding material. The distortion can be minimized during the pre-process, real-time, or postprocess stages. In the present paper, the laser forming (LF) technology is utilized for the post correction of welding-induced distortion. The out-of-plane distortion can be...
متن کاملThe Analysis of Longitudinal Shrinkage in Butt Weld Joint (TECHNICAL NOTE)
In this research longitudinal shrinkage of two steel plates with identical thickness that are joint together through butt welding and another steel plate with bead welding. This study begins withthe introduction of a model, in which the thermoelastoplastic zones near the weld line is simulated with a thermoelastoplastic flat bar, and full-elastic areas beyond the weld line is simulated with a f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Case Studies in Engineering Failure Analysis
سال: 2015
ISSN: 2213-2902
DOI: 10.1016/j.csefa.2015.05.001