Forming Limit Prediction in Bore Expansion by Combination of Finite Element Simulation and Ductile Fracture Criterion
نویسندگان
چکیده
منابع مشابه
FINITE ELEMENT PREDICTION OF DUCTILE FRACTURE IN AUTOMOTIVE PANEL FORMING: COMPARISON BETWEEN FLD AND LEMAITRE DAMAGE MODELS
In sheet metal forming processes with complex strain paths, a part is subjected to large plastic deformation. This severe plastic deformation leads to high plastic strain localization zones and subsequent accumulation of those strains. Then internal and superficial micro-defects and in other words ductile damage is created. This damage causes quality problems such as fracture. Therefore, design...
متن کاملPrediction of forming limit curves (FLD, MSFLD and FLSD) and necking time for SS304L sheet using finite element method and ductile fracture criteria
Forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. In this research, forming limit diagram (FLD) of SS304L sheet was obtained by ABAQUSfinite element software. In practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. Forming limit di...
متن کاملprediction of forming limit curves (fld, msfld and flsd) and necking time for ss304l sheet using finite element method and ductile fracture criteria
forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. in this research, forming limit diagram (fld) of ss304l sheet was obtained by abaqusfinite element software. in practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. forming limit di...
متن کاملprediction of forming limit curve using ductile fracture criteria in hydrofoming of aluminum tubes
forming limit curve (flc) is an important tool for evaluation of formability of sheet metals subjected to different loading. free bulge of aluminume tubes has been investigated numerically to obtain flc. to verify the numerical results one experimental setup has been manufactured which has the ability of controlling the internal pressure and axial feed. in this study, time and zone of bursting ...
متن کاملDetermination of Buckling Limit of Strain in Cold Roll Forming through Finite Element Analysis
In this study, Buckling Limit of Strain (B.L.S.) is introduced as one of the most important limiting factors in cold roll forming process. B.L.S. is calculated by the finite element procedure. Then for two particular processes with existing analysis and experimental results, B.L.S. has been determined and evaluated. LUSAS 12.3 is used for finite element analysis. The results show that when buck...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2009
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.p-m2009817