Forming and Welding of Non-ferrous Alloy Clad Steel (1st Report)
نویسندگان
چکیده
منابع مشابه
Cavitation Process and the Performance of Some Ferrous and Non-Ferrous Alloys
"> In this research an extensive literature search into the mechanism of cavitation dynamics and its consequences was conducted. A cavitation venturie rig was designed <span style="font-size: 10pt; col...
متن کاملCorrosion Behavior of Stainless Steel Clad Rebar
Stainless steel clad rebar (SCR) was investigated because it may become a cost-effective means of controlling corrosion in concrete under very aggressive environments. Sound SCR (316L cladding) resisted corrosion in saturated Ca(OH)2 solution (SCS) with up to 5 wt% chloride. Cladding breaks on SCR induced significant corrosion of exposed underlying CS in SCS with only 1 wt% chloride. A computer...
متن کاملComparison of Welding Processes and Control Technology Options for Clad Welding Machines
Overlay welding of nickel alloys for corrosive and sour service is commercially accomplished with most welding processes ranging from shielded metal arc (stick) to laser. The valve industry has generally standardized on hot wire gas tungsten arc (GTA-HW), pulsed gas metal arc (GMA-P) and submerged arc (SAW) welding. This document will focus on these three but a little history will help explain ...
متن کاملForming and Properties of Friction Stir Welding Process for Dissimilar Mg Alloy
For hot extrusions of magnesium alloy sheets, Dissimilar AZ80 and AZ31 were used, in which AZ80 was placed on advancing side and AZ31 on retreating side, using friction stir butt welding with different process parameters. Some defect-free welded joints with good weld surfaces could be obtained with some suitable welding conditions. The maximum tensile strength of welded joint which is 225.5 MPa...
متن کاملFeasibility study of friction stir welding of 6061-T6 aluminium alloy with AISI 1018 steel
The present work demonstrates that friction stir welding (FSW) is a feasible route for joining 6061 aluminium (Al) alloy to AISI 1018 steel. The weld has a good weld quality and is free of cracks and porosity. The tensile failure happened at the boundary between the nugget and thermomechanically affected zone of the base Al alloy, indicating that the weld has a higher joining strength. Despite ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1974
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.43.726