Formation of Transitional Ferrite Phase in an Iron-Chromium-Nickel Alloy
نویسندگان
چکیده
منابع مشابه
Positron annihilation lifetime spectroscopy in nickel ferrite and iron oxide nanopowders
In this study, a positron annihilation lifetime spectrometer was set up and its resolution was optimized. The spectrometer is a fast-slow arrangement with time resolution of 250 ps. To obtain lifetime components and their intensities from analyzing positron annihilation lifetime spectrum, the Pascual software is used. Positrons are from a source of radioactive 22NaCl with 20 μCi activity enclos...
متن کاملFrequency dependent dielectric behaviour of cadmium and chromium co-substituted nickel ferrite
The frequency dependent dielectric properties of Ni1−xCdxCrxFe2−xO4 (x = 0.0, 0.3, 0.5, 0.7 and 1.0) spinel ferrite system are studied by measuring dielectric constant (ε′), dielectric loss (D) and conductivity (σa.c) at 300 K in the frequency range 100 Hz-2 MHz. The highest value of σa.c and ε′ is observed for x = 0.3 composition. The values ε′ and σa.c decrease with increase in frequency for ...
متن کاملEffect of PFM Firing Cycles on the Mechanical Properties, Phase Composition, and Microstructure of Nickel-Chromium Alloy.
PURPOSE The purpose of this study was to compare the mechanical properties of beryllium-free nickel-chromium (Ni-Cr) dental casting alloy before and after each porcelain firing cycle (once fired, twice fired, and thrice fired) and to relate these properties to the microstructural changes and changes in X-ray diffraction patterns of Ni-Cr alloy that occur after each porcelain firing cycle. MAT...
متن کاملFormation and Evaluation of Oxidation Behavior of Zirconia- Aluminide Coating on Nickel- Based Alloy
Practical applications of thermal barrier coatings with aluminide bond-coats are limited due to oxide scale spallation of the aluminide coating under applied thermal stresses. Considering the positive effects of oxygen-active elements or their oxides on the high temperature oxidation behavior, in this research zirconia was introduced into an aluminide coating. For this purpose, a Watts type bat...
متن کاملRheological Study of Nickel Ferrite Ferrofluid
In this work, a stable NiFe2O4 paraffin based ferrofluid was prepared via high energy milling. The rheological properties of ferrofluid were studied. Bingham plastic, HerschelBulkley and Casson models were used to evaluate the shear stress-shear rate dependency. The ferrofluid exhibited a shear thinning behaviour for all studied magnetic field. The magneto-viscous effect and thixotropy of...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Institute of Metals
سال: 1972
ISSN: 0021-4434,2432-4701
DOI: 10.2320/matertrans1960.13.59