Formation of Titanium Carbonitride from Hot Metal.
نویسندگان
چکیده
منابع مشابه
Formation of nanocrystalline titanium carbonitride by pyrolysis of poly(titanylcarbodiimide)
The chemical formation of advanced ceramics from organometallic precursors is promising with respect to structural design and tailormade properties. We report on the synthesis of nanocrystalline titanium carbonitride materials at different pyrolysis temperatures via the polymer-to-ceramic transformation of synthesised poly(titanylcarbodiimides) and their structural and nanochemical characteriza...
متن کاملEvaluation of Atom-probe Spectra from Titanium Carbonitride
Four (Ti, W)(C, N)-Ni alloys with known composition have been used to investigate how the detected composition varies with crystallography, pulse ratio, nitrogen content and temperature. The interpretation of mass spectra is discussed and conditions of analysis with which correct results can be obtained are given.
متن کاملSpark-plasma-sintering (SPS) of nanostructured titanium carbonitride powders
Spark-Plasma-Sintering (SPS) compaction experiments of nanostructured titanium carbonitride powders have been performed at 1600°C and 1800°C (sintering time = 1 min). The as-received nanostructured samples have been synthesized by rapid condensation from the gas-phase (high frequency plasma). The sintering results were compared with data obtained by various conventional sintering techniques suc...
متن کاملEnhanced Electrocatalytic Performance for Oxygen Reduction via Active Interfaces of Layer-By-Layered Titanium Nitride/Titanium Carbonitride Structures
Cathode materials always limit the performance of fuel cells while the commercial platinum-based catalysts hardly meet the requirements of low cost, durable and stable. Here a non-precious metal oxygen reduction reaction (ORR) electocatalyst based on titanium nitride/titanium carbonitride hierarchical structures (TNTCNHS) is demonstrated as high activity as Pt/C. In alkaline condition, tuning i...
متن کاملInvestigation of hot metal gas forming process of square parts
Aluminum alloys are considered a lot in the automotive and aerospace industry because of their high strength to weight ratio. In this manuscript, the gas forming process of aluminum AA6063 tubes at high temperatures up to 500°C is investigated, through experimental and numerical tests. Therefore, an experimental setup is prepared and so, tube specimens are formed in a die with square cross sect...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2001
ISSN: 0915-1559
DOI: 10.2355/isijinternational.41.1417