Formation of an Intermediate Layer Between Grains in Nickel-Based Superalloy Turbine Blades
نویسندگان
چکیده
منابع مشابه
Cooling Turbine Blades using Exciting Boundary Layer
The present study is concerned with the effect of exciting boundary layer on cooling process in a gas-turbine blades. The cooling process is numerically investigated. Observations show cooling the first row of moving or stable blades leads to increase their life-time. Results show that minimum temperature in cooling line with exciting boundary layer is lower than without exciting. Using block i...
متن کاملImproving the oxidation resistance of nickel - based superalloys for turbine blades
I. Introduction: Challenges in energy savings for turbines engines Nickel-based superalloys can withstand high temperatures and severe oxidizing conditions, while maintaining superb mechanical properties. Because of this, they are widely used for aerospace and power generation applications. Since higher operating temperature leads to greater cycle efficiency, there are economic and environmenta...
متن کاملMaterials for Wind Turbine Blades: An Overview
A short overview of composite materials for wind turbine applications is presented here. Requirements toward the wind turbine materials, loads, as well as available materials are reviewed. Apart from the traditional composites for wind turbine blades (glass fibers/epoxy matrix composites), natural composites, hybrid and nanoengineered composites are discussed. Manufacturing technologies for win...
متن کاملAn Innovation in Film Cooling of the Gas Turbine Blades Applying an Upstream Jet
A new design concept is introduced to control the near-wall integration between the hot-gas boundary layer and the cooling jets in order to enhance the adiabatic film cooling effectiveness of the gas turbine blades. In this new approach, another film cooling port, having a very low blowing ratio, which prevents formation of the counter-rotating vortex pare, is applied just upstream of the main ...
متن کاملSelective Growth of Low Stored Energy Grains During δ Sub-solvus Annealing in the Inconel 718 Nickel-Based Superalloy
The microstructure stability during d sub-solvus annealing in Inconel 718 was investigated, focusing on the conditions that may lead to the development of very large grains (about 100 lm) in a recrystallized fine grained matrix (4 to 5 lm) despite the presence of second-phase particles. Microstructure evolution was analyzed by EBSD (grain size, intragranular misorientation) and SEM (d phase par...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metallurgical and Materials Transactions A
سال: 2017
ISSN: 1073-5623,1543-1940
DOI: 10.1007/s11661-017-4044-7