Formation Behavior of Nanostructural Layer Induced by Sliding Wear
نویسندگان
چکیده
منابع مشابه
suppression of coke formation in thermal cracking by coke inhibitors
the main purpose of this research was to:1.develop a coking model for thermal cracking of naphtha.2.study coke inhibition methods using different coke inhibitors.developing a coking model in naphtha cracking reactors requires a suitable model of the thermal cracking reactor based on a reliable kinetic model.to obtain reliable results all these models shall be solved simultaneously.for this pu...
15 صفحه اولDry Sliding Wear Behavior of Epoxy-Rubber Dust Composites
Composite pins of rubber dust collected from tyre retreading centres of trucks, cars and buses etc.and epoxy with weight percentages of 10. 15, and 20 % of rubber (weight fractions of 9, 13 and 17 % respectively) have been prepared in house with the help of a split wooden mould. The pins were tested in a pin-on-disc wear monitor to determine the co-efficient of friction and weight losses with v...
متن کاملThe Wear Behavior of Textured Steel Sliding against Polymers
Artificially fabricated surface textures can significantly improve the friction and wear resistance of a tribological contact. Recently, this surface texturing technique has been applied to polymer materials to improve their tribological performance. However, the wear behavior of textured tribo-pairs made of steel and polymer materials has been less thoroughly investigated and is not well under...
متن کاملSliding Wear Behavior of UNS R56400 Titanium Alloy Samples Thermally Oxidized by Laser
Wear of elements subjected to friction and sliding is among the main causes of low tribological performance and short lifetime of strategic materials such as titanium alloys. These types of alloys are widely used in different areas such as aerospace and the biomechanics industry. In this sense, surface modification treatments allow for the overcoming of limitations and improvement of features a...
متن کاملWear of fluorapatite single crystals: IV. Influence of sliding direction on frictional behavior and surface failure.
Preliminary studies of the wear of fluorapatite single crystals subjected to sliding neglected the possible influence of crystallographic direction on the frictional behavior and surface failure of the basal plane.1-3 In these studies, possible anisotropic effects were considered to contribute to the experimental error in the analysis of the data. Buckley4 has observed that friction coefficient...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materia Japan
سال: 2011
ISSN: 1340-2625
DOI: 10.2320/materia.50.331