Formability Improvement by Die-bearing Grooves in Tube Extrusion with Spiral Inner Projections
نویسندگان
چکیده
منابع مشابه
Numerical Investigations on the Effect of Pulsating Pressure on Improvement of Formability in Hydroforming of Bent Tube by FEM
In this paper, hydroforming process of bent tubes in T-shaped die is studied for pulsating and linear pressure paths by the finite element method. Forming Limit Diagrams (FLDs) and thickness distribution curves are used to investigate the effect of pulsating pressure on hydroforming process. In addition, the obtained numerical results are compared with experimental results of hydroforming of st...
متن کاملResearch on the Micro Pattern forming of Spiral Grooves in a Dynamic Thrust Bearing
This paper deals with a novel technique for the fabrication of Spiral grooves in a dynamic thrust bearing. The main scheme proposed in this paper is to fabricate the microgrooves using desktop forming system. This process has advantages compared to the conventional electro-chemical machining in the viewpoint of a higher productivity. For this reason, a new testing apparatus is designed and buil...
متن کاملOptimization of Axisymmetric Extrusion Die Profiles
In this research, optimization process of axisymmetric extrusion dies is proposed. Plastic zone is analyzed using finite element method in the Eulerian system with flow formulation. The die profiles are defined by Bezier curves with six control points. Two effective functions are considered in this research; standard deviation of the strain rate and the rate of energy consumption during extrusi...
متن کاملAluminum extrusion with a deformable die
In aluminum extrusion, a work-piece (billet) is pressed through a die with an opening that closely resembles the desired shape of a profile. By this process, long profiles with an enormous variety of cross-sections can be produced to serve different markets such as building, construction and transport industry. When the shape of a profile does not conform to the specifications defined by the cu...
متن کاملB Ball Bearing ▶ Bearing Bar Extrusion
Introduction Bar extrusion is a process in which a block of metal (billet) is forced to flow by compression through a tool (die) opening of a smaller crosssectional area than that of the original billet. There are two basic types of bar extrusion: direct and indirect. The most important and common method used is the direct extrusion (Lange 1988). Figure 1 shows the principle of direct bar extru...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2014
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2014.10.053