Formability Estimation of Ring Rolling Process by using Deformation Processing Map
نویسندگان
چکیده
منابع مشابه
Optimization of Hot Workability in Ti-IF Steel by Using the Processing Map
Processing map for hot working of Ti-IF steel has been developed in the temperature range of 750 to 1100 °C and strain rate of 0.01 to 100 s-1. This map in the austenite region exhibits a single domain with a peak efficiency of 45% occurring at 1025 °C and strain rate of 0.02 s-1. The domain extends over the temperature range of 1000 to 1100 °C and strain rate range of 0.01 to 1 s-1. The true s...
متن کاملGrain Size Effect on the Hot Deformation Processing Map of AISI 304 Austenitic Stainless Steel
In this study, the hot deformation processing map of AISI 304 austenitic stainless steel in two initial grain sizes of 15 and 40 μm was investigated. For this purpose, cylindrical samples were used in the hot compression test at the temperature range of 950-1100 °C and the strain rate of 0.005-0.5% s-1. At first, the relationship between the peak stress and Zener-Hollomon parameter w...
متن کاملNUMERICAL SIMULATION OF RING ROLLING PROCESS FOR Ni-BASE ARTICLES
Continuous improvements of properties for individual parts are indispensable for perpetual development of aircraft engines. Concerning casing and seal, simulation of ring rolling process is one of the most attractive tools to reduce the cost and time and to improve the properties and the reliability at the same time. In order to obtain both practical prediction accuracy and acceptable computati...
متن کاملinvestigation of process parameters on hot ring rolling by coupled thermo-mechanical 3d-fea
hot rolling of a large ring of titanium alloy (lrt) is a highly nonlinear incremental forming process with coupled mechanical and thermal behaviors (mtbs) which significantly affect microstructure and properties of the ring. the feed rate of idle roll and the rotational speed of driver roll have major effects on ovality of the ring. in this paper, the effects of these parameters on the ovality ...
متن کاملThe Effects of Forming Parameters on Conical Ring Rolling Process
The plastic penetration condition and biting-in condition of a radial conical ring rolling process with a closed die structure on the top and bottom of driven roll, simplified as RCRRCDS, were established. The reasonable value range of mandrel feed rate in rolling process was deduced. A coupled thermomechanical 3D FE model of RCRRCDS process was established. The changing laws of equivalent plas...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2014
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2014.09.167