Forging Quenching and Cooling Control Equipment.
نویسندگان
چکیده
منابع مشابه
Computational Model For Spray Quenching Of A Heavy Forging
Considering heavy forged parts presented that water spray is an appropriate technique as quenching operation. In general, the rapid cooling causes residual stress field due to the dis-homogeneity of the distribution of temperature in the part and the different microstructural phases. In comparison with other conventional quenching methods, spray-quenching method could have a capability to contr...
متن کاملThe cooling process in gas quenching
Gas quenching is a relatively new process with several important advantages, such as minimal environmental impact, clean products, and ability to control the cooling locally and temporally for best product properties. To meet the high cooling rates required for quenching, the cooling gas must flow at very high velocities, and such flows are highly turbulent and separated. Consequently, there is...
متن کاملAutomated Fault Detection and Diagnostics for Vapor Compression Cooling Equipment
Automated fault detection and diagnostic (FDD) systems have the potential to reduce equipment downtime, service costs, and utility costs. However, very few commercial products exist and the ones that do exist are very specialized. This may be surprising to some, considering that FDD is very well developed for other applications such as for nuclear power plants, aircraft, chemical process plants...
متن کاملForging Process Control by Additional Rocket Force
Technological processes such as forging, die forging, and pile driving are realized as a result of a collision between two bodies. After the impact the bodies’ energy transforms to plastic or elastic deformations of the colliding bodies. This paper studies both theoretically and experimentally the influence of impact parameters such as forces, accelerations, velocities, time and energy on defor...
متن کاملOptimization of Spray Quenching for Aluminum Extrusion, Forging, or Continuous Casting
I N T R O D U C T I O N Mechanical and metallurgical requirements impose limits on the rates at which aluminum alloys can be quenched by water sprays. The upper limit is set by the occurrence of plastic deformation which causes warping of the product and the lower limit is set by an inability to develop the required metallurgical properties in subsequent heat treatment operations. In addition, ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: DENKI-SEIKO[ELECTRIC FURNACE STEEL]
سال: 1992
ISSN: 1883-4558,0011-8389
DOI: 10.4262/denkiseiko.63.82