Forevacuum plasma source of continuous electron beam
نویسندگان
چکیده
منابع مشابه
A Reflex Electron Beam Discharge as a Plasma Source for Electron Beam Generation
A reflex electron beam glow discharge has been used as a plasma source for the generation of broad-area electron beams. An electron current of 120 A ( 12 A/cm2) was extracted from the plasma in 10 ps pulses and accelerated to energies greater than 1 keV in the gap between two grids. The scaling of the scheme for the generation of multikiloamp high-energy electron beams is discussed. E HAVE demo...
متن کاملLow-Energy Plasma Focus Device as an Electron Beam Source
A low-energy plasma focus device was used as an electron beam source. A technique was developed to simultaneously measure the electron beam intensity and energy. The system was operated in Argon filling at an optimum pressure of 1.7 mbar. A Faraday cup was used together with an array of filtered PIN diodes. The beam-target X-rays were registered through X-ray spectrometry. Copper and lead line ...
متن کاملContinuous Electron Beam Accelerator Facility,
We use local quark-hadron duality to estimate the purely nonperturbative soft contribution to the γ * p → ∆ form factors. Our results are in agreement with existing experimental data. We predict that the ratio G * E (Q 2)/G * M (Q 2) is small for all accessible Q 2 , in contrast to the pQCD expectations that G * E (Q 2) → −G * M (Q 2).
متن کاملLinac Coherent Light Source Electron Beam Collimation∗
This paper describes the design and simulation of the electron beam collimation system in the Linac Coherent Light Source (LCLS). Dark current is expected from the gun and some of the accelerating cavities. Particle tracking of the expected dark current through the entire LCLS linac, from gun through FEL undulator, is used to estimate final particle extent in the undulator as well as expected b...
متن کاملAn Electron Beam Heated Evaporation Source
An electron beam evaporator has been assembled, tested and used for deposition of thin nickel films. Flux and deposition rates has been measured with an oscillating quartz crystal monitor (QCM), an ion sensor wire, and visible deposition on a mirror on front of the evaporator. A thin nickel rod of 2 mm diameter was found to improve the pressure in comparison to a 6-mm nickel rod. The flux was t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Laser and Particle Beams
سال: 2019
ISSN: 0263-0346,1469-803X
DOI: 10.1017/s0263034619000375