Forced Convective and Nucleate Flow Boiling Heat Transfer to Alumnia Nanofluids
نویسندگان
چکیده
منابع مشابه
Convective Heat Transfer of Binary Mixtures under Flow Boiling Conditions
The present study represents part of an effort in considering the replacement of ethylene-glycol/water mixtures with propyleneglycol/water mixtures for engine cooling in automotive application. Experimental results are presented for the heat transfer coeffic ient under flow boiling conditions for water and mixtures of water with ethylene-glycol and propylene-glycol. The range covered includes t...
متن کاملEntropy Generation Analysis and Performance Evaluation of Turbulent Forced Convective Heat Transfer to Nanofluids
The entropy generation analysis of fully turbulent convective heat transfer to nanofluids in a circular tube is investigated numerically using the Reynolds Averaged Navier–Stokes (RANS) model. The nanofluids with particle concentration of 0%, 1%, 2%, 4% and 6% are treated as single phases of effective properties. The uniform heat flux is enforced at the tube wall. To confirm the validity of the...
متن کاملNucleate Pool Boiling Heat Transfer to Al2O3-Water and TiO2-Water Nanofluids on Horizontal Smooth Tubes with Dissimilar Homogeneous Materials
Nucleate pool boiling heat transfer coefficients of Al2O3-water and TiO2-water nanofluids have been experimentally measured on three horizontal tubes with different materials and similar roughness under atmospheric pressure. Results revealed that the presence of nanoparticles in the base fluid leads to an increase in pool boiling heat transfer coefficients on stainless steel and brass tubes in ...
متن کاملEntropy generation calculation for laminar fully developed forced flow and heat transfer of nanofluids inside annuli
In this paper, second law analysis for calculations of the entropy generation due to the flow andheat transfer of water-Al2O3 and ethylene glycol-Al2O3 nanofluids inside annuli is presented. Thephysical properties of the nanofluids are calculated using empirical correlations. Constant heatfluxes at inner surface of the annuli are considered and fully developed condition for fluid flowand heat t...
متن کاملHeat transfer in nucleate pool boiling of multicomponent mixtures
Steady state pool boiling heat transfer coefficients have been obtained experimentally for acetone–isopropanol–water and acetone–MEK (methyl ethyl ketone)–water ternary systems. The data show that, for a given heat flux, the heat transfer coefficients of mixtures are lower than those obtained for pure components constituting the mixture. The measured heat transfer coefficients were compared wit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Periodica Polytechnica Chemical Engineering
سال: 2014
ISSN: 0324-5853,1587-3765
DOI: 10.3311/ppch.2206