Foaming Agents for Powder Metallurgy Production of Aluminum Foam

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

High Porosity Metallic Glass Foam: A Powder Metallurgy Route

A powder metallurgy route to the fabrication of metallic glass foam is introduced. The method involves consolidating metallic glass powder blended with blowing agent particulates to produce expandable precursors, capable of yielding foams with porosities as high as 86%. The foams are found to inherit the strength of the parent metallic glass, and to be able to deform heavily toward full densifi...

متن کامل

Accelerated Threshold Fatigue Crack Growth Effect – Powder Metallurgy Aluminum Alloy

Fatigue crack growth (FCG) research conducted in the near threshold regime has identified a room temperature creep crack growth damage mechanism for a fine grain powder metallurgy (PM) aluminum alloy (8009). At very low ∆K, an abrupt acceleration in room temperature FCG rate occurs at high stress ratio (R = Kmin/Kmax). The near threshold accelerated FCG rates are exacerbated by increased levels...

متن کامل

Compressibility and Foaming behavior of steel slag/waste glass compositesby particle size distribution and foam agents

In present research, the foam glass-ceramic composites fabricated by window glass, steel slag and SiC, CaCO3 foaming agents were investigated by press–sintering method. The optimum sintering temperature was obtained at 1200°C with a 3-minutes holding time and 20°C/min heating rate. The optimum pressure level of 80 MPa for achieving the 70 % of relative density was selected. The effec...

متن کامل

Simulation of Foaming and Deformation for Composite Aluminum Foams

In this study, at the first stage, the rupture criterion of bubbles wall in Aluminum metal foam liquid was investigated by using Lattice Boltzmann. The two phases modeling were accomplished by using a modified Shan-Chen model. This model was run for several bubbles in A356+3wt.%SiC melt system. Then, bubbles morphologies (virtual metallographic) for A356+3wt.%SiC foams were simulated. Results s...

متن کامل

Production of Nigella sativa Beverage Powder under Foam Mat Drying Using Egg Albumen as a Foaming Agent

The aim of this study was to determine the feasibility of producing Nigella sativa powder under a foam mat drying technique. A central, composite design of experiments was used to optimize the drying condition and compare the solubility, the antioxidant and mineral content of roasted Nigella sativa, and the foam mat dried Nigella sativa powder. Foams were prepared from Nigella sativa solution b...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: MATERIALS TRANSACTIONS

سال: 2011

ISSN: 1345-9678,1347-5320

DOI: 10.2320/matertrans.m2010401