Fluctuations of Tracks and Layers during Aluminium Laser Powder-Bed Fusion
نویسندگان
چکیده
منابع مشابه
Measurement of the Melt Pool Length during Single Scan Tracks in a Commercial Laser Powder Bed Fusion Process
Contact author: [email protected] Certain commercial equipment, instruments, or materials are identified in this paper in order to specify the experimental procedure adequately. Such identification is not intended to imply recommendation or endorsement by the National Institute of Standards and Technology, nor is it intended to imply that the materials or equipment identified are necessari...
متن کاملFunctionalization of Biomedical Ti6Al4V via In Situ Alloying by Cu during Laser Powder Bed Fusion Manufacturing
The modern medical industry successfully utilizes Laser Powder Bed Fusion (LPBF) to manufacture complex custom implants. Ti6Al4V is one of the most commonly used biocompatible alloys. In surgery practice, infection at the bone-implant interface is one of the key reasons for implant failure. Therefore, advanced implants with biocompatibility and antibacterial properties are required. Modificatio...
متن کاملStudy of the Microstructure and Cracking Mechanisms of Hastelloy X Produced by Laser Powder Bed Fusion
Hastelloy X (HX) is a Ni-based superalloy which suffers from high crack susceptibility during the laser powder bed fusion (LPBF) process. In this work, the microstructure of as-built HX samples was rigorously investigated to understand the main mechanisms leading to crack formation. The microstructural features of as-built HX samples consisted of very fine dendrite architectures with dimensions...
متن کاملLaser powder bed fusion of Ti-6Al-4V parts: Thermal modeling and mechanical implications
A continuum-scale modeling approach is developed and employed with three-dimensional finite element analysis (FEA), for simulating the temperature response of a Ti-6Al-4V, two-layered parallelepiped with dimensions of 10×5×0.06 mm during Laser Powder Bed Fusion (L-PBF), a metals additive manufacturing (AM) method. The model has been validated using experimental melt pool measurements from the l...
متن کاملLaser Penetration in a Powder Bed during Selective Laser Sintering of Metal Powders: Simulations versus Experiments
To gain a better understanding and control of the Selective Laser Sintering (SLS) process, more fundamental and modeling work is needed. A simple analytical ray-tracing model has been developed to simulate the energy absorption and penetration in SLS. The model is applied to FeCu and WC-Co powder mixtures, irradiated by Nd-YAG or CO2 laser. It gives an evaluation of the total energy incoupling ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Applied Sciences
سال: 2021
ISSN: 2076-3417
DOI: 10.3390/app11073132