Flow Softening of 7075 Aluminum Alloy under Hot Compression
نویسندگان
چکیده
منابع مشابه
An Investigation on the Softening Mechanism of 5754 Aluminum Alloy during Multistage Hot Deformation
Isothermal interrupted hot compression tests of 5754 aluminum were conducted on a Gleeble-3500 thermo-mechanical simulator at temperatures of 350 °C and 450 °C, and strain rates of 0.1 s−1 and 1 s−1. To investigate the metadynamic recrystallization behavior, a range of inter-pass delay times (5–60 s) was employed. These tests simulated flat rolling to investigate how softening behaviors respond...
متن کاملImproving Mechanical Properties of PVPPA Welded Joints of 7075 Aluminum Alloy by PWHT
In this study, 7075 aluminum alloy with a thickness of 10 mm was successfully welded with no obvious defects by pulsed variable polarity plasma arc (PVPPA) welding. The mechanical properties of PVPPA welded joints have been researched by post weld heat treatment (PWHT). The results indicate that the heat treatment strongly affects the mechanical properties of the welded joints. The tensile stre...
متن کاملDevelopment of an Artificial Neural Network Constitutive Model for Aluminum 7075 Alloy
Development of an accurate neuronal material model for aluminum alloys would facilitate better process control and parameter optimization in the aircraft industry. This research primarily attempts to design a connectionist constitutive model for aluminum 7075 alloy using multi-layer perceptrons. The backpropagation algorithm is used to train the designed network whose performance is then valida...
متن کاملApplication of the GTN Model in Ductile Fracture Prediction of 7075-T651 Aluminum Alloy
In this paper the capability of Gurson-Tvergaard-Needleman (GTN) model in the prediction of ductile damage in 7075-T651 aluminum alloy is investigated. For this purpose, three types of specimens were tested: Standard tensile bars, Round notched bar (RNB) specimens and compact tension (C(T)) specimens. Standard tensile bar tests were used to obtain the mechanical properties of the material and t...
متن کاملDetecting Milling Deformation in 7075 Aluminum Alloy Aeronautical Monolithic Components Using the Quasi-Symmetric Machining Method
The deformation of aeronautical monolithic components due to CNC machining is a bottle-neck issue in the aviation industry. The residual stress releases and redistributes in the process of material removal, and the distortion of the monolithic component is generated. The traditional one-side machining method will produce oversize deformation. Based on the three-stage CNC machining method, the q...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Transactions, JIM
سال: 1991
ISSN: 0916-1821,2432-471X
DOI: 10.2320/matertrans1989.32.375