FLOW REGIMES IN COMMERCIAL METAL FOAM HAVING 10 PORES PER INCH
نویسندگان
چکیده
منابع مشابه
Experimental Investigation on the Effect of Partially Metal Foam inside the Absorber of Parabolic Trough Solar Collector
In the present work the efficiency of a solar parabolic trough has been investigated experimentality. parabolic trough solar collector constitute a proven source of thermal energy for industrial process heat and power genaration. The impact of using the partially porous media in the absorber on the efficiency of PTC (parabolic trough collector) has been investigated. The porosity of copper foa...
متن کاملایجاد لایه سوپرآلیاژ بر روی فوم های نیکلی توسط عملیات پاشش گرمایی
Open pore metallic foams can be used for high temperature, high performance heat exchanger due to their high gas permeability and heat conductivity provided that skins properly attach to the foam’s struts on the surface. In the current study, a novel process was successfully developed to fill pores on the surface of the foam sheet in order to deposit skin on the foam specimens by thermal sprayi...
متن کاملMetal Foam and Finned Metal Foam Heat Sinks for Electronics Cooling in Buoyancy-Induced Convection
In this paper, we present our recent experimental results on buoyancy-induced convection in aluminum metal foams of different pore densities [corresponding to 5, 10, 20, and 40 pores per in. (PPI)] and porosities (0.89–0.96). The results show that compared to a heated surface, the heat transfer coefficients in these heat sinks are five to six times higher. However, when compared to commercially...
متن کاملDirectionally freeze-cast titanium foam with aligned, elongated pores
Directional freeze-casting – a process used to create foams with elongated, aligned pores applied so far exclusively for ceramics – is demonstrated for titanium foams. An aqueous slurry of <45 lm titanium powders was directionally solidified, resulting in a powder preform consisting of elongated, aligned dendrites of pure ice separated by interdendritic regions with high powder content. After f...
متن کاملFabrication and Characterization Ofhigh Performance Ceramic Membrane Having Nanometre Pores
In this study, carbon nanotubes (CNTs) were grown directly in the pores of micro porous pyrex membranes and consequently ceramic membranes with very fine pores and high porosity were achieved. Our experiment was done in two stages. Initially cobalt powder with different percent was homogeneously mixed with pyrex powder. In order to produce row membranes, each of these mixtures were compacted in...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Thermal Engineering
سال: 2016
ISSN: 2148-7847
DOI: 10.18186/jte.52093