Flow Pattern Analysis and Performance Improvement of Regenerative Flow Pump Using Blade Geometry Modification

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Modification of flow and compressibility of corn starch using quasi-emulsion solvent diffusion method

Objective(s):The aim of this study was to improve flowability and compressibility characteristics of starch to use as a suitable excipient in direct compression tabletting. Quasi-emulsion solvent diffusion was used as a crystal modification method. Materials and Methods: Corn starch was dissolved in hydrochloric acid at 80˚C and then ethanol as a non-solvent was added with lowering temperature ...

متن کامل

Performance Prediction Modeling of Axial-Flow Compressor by Flow Equations

Design models of multi- stage, axial flow compressor are developed for gas turbine engines. Axial flow compressor is one of the most important parts of gas turbine units. Therefore, its design and performance prediction are very important. One-dimensional modeling is a simple, fast and accurate method for performance prediction of any type of compressors with different geometries. In this appro...

متن کامل

CFD Analysis of a Regenerative Pump for Performance Enhancement

Regenerative centrifugal pumps (RCP) are the subject of increased interest in industry as these pumps produce less noise, have low specific speed and are compact but capable of delivering high heads with stable performance characteristics. The regenerative flow pumps are essentially rotodynamic turbo machines capable of developing high pressure ratios within a single stage. This paper presents ...

متن کامل

Numerical Simulation of Cavitation in Mixed Flow Pump

The purpose of this study is to investigate the performance and three-dimensional behavior of the flow in a mixed flow pump and the way cavitation phenomenon is affected by different parameters such as fluid temperature, pump speed and flow rate. Computational fluid dynamic software FLUENT 6.3 was utilized to simulate the whole flow field of the pump. RNG k-ε model combined with standard wall f...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: International Journal of Rotating Machinery

سال: 2016

ISSN: 1023-621X,1542-3034

DOI: 10.1155/2016/8628467