Flow mechanism of .LAMBDA.-type pseudoshock waves in a straight-square duct.
نویسندگان
چکیده
منابع مشابه
Travelling waves in a straight square duct
Isothermal, incompressible flow in a straight duct with square cross-section is known to be linearly stable [1]. Direct numerical simulation, on the other hand, has revealed that turbulence in this geometry is self-sustained above a Reynolds number value of approximately 1100, based on the bulk velocity and the duct half-width [2]. Numerous non-linear equilibrium solutions have already been ide...
متن کاملThree-dimensional traveling waves in a square duct.
A nonlinear streamwise traveling-wave solution is obtained by homotopy for square duct flow. For a particular symmetry of the perturbations, this wave comes into existence at about Re(b)=600 (based on half-duct width and bulk speed) for a streamwise wave number alpha=0.85 . The resulting four-vortex mean flow resembles the transitional flow structures observed in previous simulations.
متن کاملCharacterisation of Marginally Turbulent Square Duct Flow
We have performed direct numerical simulation of fully developed turbulent flow in a straight duct with square cross-section. The main objective of the present study is to determine the minimal requirements for maintaining turbulence in duct flows [1]. A detailed analysis of this limit regime allows to elucidate the dominant mechanisms governing the marginally turbulent state, where the self-su...
متن کاملHeat transfer in MHD square duct flow of nanofluid with discrete heat sources
The effect of thermal and solutal buoyancy induced by a discrete source of heat and mass transfer in a square duct under the influence of magnetic field, especially at the turbulent regime for the first time is reported. Al2O3/water nanofluid is used with constant heat flux from three discrete heat sources. In the present study, the effects of Reynolds number (100 to 3000), particle volume frac...
متن کاملSquare Joints in Railway Track Waves
When rails are laid in a railway track, small gaps are left between the ends of adjoining rails to allow for the expansion of the rails when the temperature rises. Rail joints are provided to form a continuous rail path which are normally laid in standard lengths bolted together by fishplates. When two rail joints are exactly opposing each other, they are called square (side by side) joints...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 1990
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.56.330