Flow measurement of wet CO 2 using an averaging pitot tube and coriolis mass flowmeters
نویسندگان
چکیده
منابع مشابه
Flowmetry (flow measurement)
Flowmetry. Fluid-flow measurement and visualisation ................................................................................ 1 Measuring mass flow-rate ......................................................................................................................... 2 Accumulative weighting .............................................................................................
متن کاملAveraging Pitot Tubes; Fact and Fiction
An experimental investigation has been undertaken to elucidate effects of averaging stagnation pressures on estimated velocities for pressure averaging instruments such as averaging Pitot tubes or velocity grids. The data from this study suggests that although an averaging Pitot tube does accurately measure the average stagnation and dynamic pressure, errors in the average of the velocity or vo...
متن کاملAn in - Situ Verification Technology for Coriolis Flowmeters
Structural Integrity Meter Verification is a robust new Coriolis verification technology which uses the onboard electronics to very accurately measure the stiffness of the flowtubes. The flow tube stiffness is directly related to the flow calibration factor and is uninfluenced by process conditions. Meter Verification compares the measured stiffness to the factory baseline stiffness to confirm ...
متن کاملan investigation into translation of cultural concepts by beginner and advance student using think – aloud protocols
this research aims at answering the questions about translation problems and strategies applied by translators when translating cultural concepts. in order to address this issue, qualitative and quantitative study were conducted on two groups of subjects at imam reza international university of mashhad. these two groups were assigned as beginner and advanced translation students (10 students). ...
Characterization of Chimney Flue Gas Flows Flow Rate Measurements with Averaging Pitot Probes
Performance testing methods of boilers in transient operating conditions (start, stop and combustion power modulation sequences) need the combustion rate quantified to allow for the emissions to be quantified. One way of quantifying the combustion rate of a boiler during transient operating conditions is by measuring the flue gas flow rate. The flow conditions in chimneys of single family house...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Greenhouse Gas Control
سال: 2017
ISSN: 1750-5836
DOI: 10.1016/j.ijggc.2017.06.005