FLOW DUE TO A VORTEX PAIR CONFINED BY PARALLEL FLAT PLATES
نویسندگان
چکیده
منابع مشابه
Entropy Generation Due to Laminar Incompressible Forced Convection Flow Through Parallel-Plates Microchannel
The entropy generation due to steady laminar forced convection fluid flow through parallel plates microchannel is investigated numerically. The effect of Knudsen, Reynolds, Prandtl, Eckert numbers and the nondimensional temperature difference on entropy generation within the microchannel is discussed. The fraction of the entropy generation due to heat transfer to the total entropy generation wi...
متن کاملThree-Dimensional Micropolar Flow due to a Stretching Flat Surface†
A numerical solution of the steady boundary layer equations under similarity assumptions is obtained for the three-dimensional flow of a micropolar fluid over a continuous stretching surface. The case when microrotation vector is zero on the solid surface is considered. Using properly similarity variables, the three-dimensional Navier – Stokes equations are reduced to a set of four coupled non-...
متن کاملPhase diagram of hard spheres confined between two parallel plates
A hard sphere system confined between two parallel hard plates is investigated theoretically. Using extensive Monte Carlo computer simulations, the phase diagram is calculated for the whole range of densities and plate separations ranging from one to two particle diameters. There occurs a strong first-order fluid freezing transition and both very weak and strong discontinuous phase transitions ...
متن کاملAxisymmetric vortex breakdown Part 1. Confined swirling flow
A comparison between the experimental visualization and numerical simulations of the occurrence of vortex breakdown in laminar swirling flows produced by a rotating endwall is presented. The experimental visualizations of Escudier (1984) were the first to detect the presence of multiple recirculation zones and the numerical model presented here, consisting of a numerical solution of the unstead...
متن کاملVortex Sheet Roll-up Due to the Motion of a Flat Plate
The vortex-blob method is extended to compute vortex sheet separation at a sharp edge. A smoothing parameter con trols the amount of detail occuring in the rolled-up spiral. Cal culations are presented for the case of vortex sheet roll-up due to an impulsively started flat plate.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF THE FLOW VISUALIZATION SOCIETY OF JAPAN
سال: 1988
ISSN: 1884-0361,0287-3605
DOI: 10.3154/jvs1981.8.supplement_149