Flow characteristics of spray impingement in PFI injection systems
نویسندگان
چکیده
منابع مشابه
Modelling of Gasoline Spray Impingement
This paper is concerned with aspects of gasoline spray droplet impingement simulation, for which an improved model has been developed for predicting the outcomes of spray droplets impacting on a wall. The model is assessed by simulating experiments on oblique spray impingement in a wind tunnel. This is done with the aid of a specially-devised procedure for deducing the specification of initial ...
متن کاملThermal Performance of Jet Impingement with Spent Flow Management
The present study proposes novel micro-jet impingement heat sink with effusion holes for flow extraction. The design consists of impingement nozzles surrounded by multiple effusion holes to take away the spent fluid. A three-dimensional numerical model is used for steady, incompressible, laminar flow and conjugate heat transfer for the performance analysis of the proposed design. The computatio...
متن کاملFuel spray visualization and its impingement analysis on in-cylinder surfaces in a direct-injection spark-ignition engine
Experiments are performed to investigate the effects of fuel spray on in-cylinder mixture preparation and its impingement on cylinder walls and piston top inside a direct-injection spark-ignition engine with optical access to the cylinder. Novel image processing algorithms are developed to analyze the fuel impingement quantitatively on in-cylinder surfaces. The technique is useful to optimize t...
متن کاملTurbulent characteristics in flow subjected to bed suction and jet injection as a pier-scour countermeasure
The effect of a combined system of the bed suction and jet injection as a pier-scour countermeasure on the turbulent flow field is studied in a laboratory flume using an Acoustic Doppler Velocimeter (ADV). The three components of the velocities in the vertical symmetry plane in the equilibrium scour hole in front and rear of the pier under 3-jet injections and bed suction rate Qs/Q0 = 2%located...
متن کاملLiquid Film Dynamic on the Spray Impingement Modelling
The present paper addresses a liquid film sub-model included into a computational model that aims at reproducing the spray impingement phenomena. This numerical extension incorporates the spread of the liquid film over the neighbouring nodes due to the dynamic motion induced by the film inertia but also the exchange of mass between the liquid layer and the incident and splashing particles. More...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Experiments in Fluids
سال: 2005
ISSN: 0723-4864,1432-1114
DOI: 10.1007/s00348-005-0996-2