Flow Characteristics in a Single Phase Closed Thermosyphon
نویسندگان
چکیده
منابع مشابه
Two-phase Closed Thermosyphon with Nanofluids
Nanofluids, stabilized suspensions of nanoparticles typically < 100 nm in conventional fluids, are evolving as potential enhanced heat transfer fluids due to their better thermal conductivity, increase in single phase heat transfer coefficient and significant increase in critical boiling heat flux. In the present paper, we investigate the overall thermal resistance of a closed two-phase thermos...
متن کاملExperimental Investigation of Boiling and Condensation Heat Transfer of a two Phase Closed Thermosyphon
In this paper the heat transfer characteristics of a two-phase closed thermosyphon over a wide range of heat transfer rates, system pressure, aspect ratios and filling ratios were studied. The experiments focused on the boiling and condensation heat transfer characteristics of the thermosyphon. The experimental boiling and condensation heat transfer coefficients inside the thermosyphon were com...
متن کاملExperimental Investigation of Boiling and Condensation Heat Transfer of a Two Phase Closed Thermosyphon
In this paper the heat transfer characteristics of a two-phase closed thermosyphon over a wide range of heat transfer rates, system pressure, aspect ratios and filling ratios were studied. The experiments focused on the boiling and condensation heat transfer characteristics of a thermosyphon with a copper tube having 25 and 32 mm inside and outside diameters. Distilled water was used as the wor...
متن کاملDiffusion Induced Chaos in a Closed Loop Thermosyphon
The dynamics of a closed loop thermosyphon are considered. The model assumes a prescribed heat flux along the loop wall and the contribution of axial diffusion. The well-posedness of the model which consists of a coupled ODE and PDE is shown for both the case with diffusion and without diffusion. Boundedness of solutions, the existence of an attractor, and an inertial manifold is proven, and an...
متن کاملNumerical Study of Single Phase/Two-Phase Models for Nanofluid Forced Convection and Pressure Drop in a Turbulence Pipe Flow
In this paper, the problem of turbulent forced convection flow of water- alumina nanofluid in a uniformly heated pipe has been thoroughly investigated. In numerical study, single and two-phase models have been used. In single-phase modeling of nanofluid, thermal and flow properties of nanofluid have been considered to be dependent on temperature and volume fraction. Effects of volume fraction a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series B
سال: 2004
ISSN: 0387-5016,1884-8346
DOI: 10.1299/kikaib.70.2349