Flow and Vibration in the Small Steam Turbine Last Stage

Study of the Effects of Lacing Rods Location on Natural Frequencies in Last Stage Blades of a Steam Turbine

In this study, effects of lacing rods location on natural frequencies of last stage of a Steam Turbine Blades (STBs) have been investigated. STBs are critical and important elements in a turbine as well as power plants. One of the most important parameters in turbine blades is lacing rods location. In this paper, first, a three dimensional (3D) scan was used to produce the geometrical model of ...

Vibration analysis of a steam turbine blade

ABSTRACT Blade failure is a common problem of a steam turbine and it’s failure in-service results in safety risks, repair cost and non operational revenue losses. Thus, the reliability of these blades is very important for the successful operation of a steam turbine. Dynamic analysis of a steam turbine blade in computational environment is carried out in the present work. In order to gain physi...

Fault Diagnosis for Steam-flow Exciting Vibration of Ultra Supercritical 1000 MW Steam Turbine

With the increase in thermal power capacity, ultra supercritical units have become the mainstream of power industry. At the same time, with the improvement of the steam parameters and the lengthening of shafting, the production of steam flow excited vibration is frequent in the ultra supercritical units, which may seriously affect the reliability of the unit. This paper has taken steam flow exc...

Numerical Modeling of Wet Steam Flow in Steam Turbine Channel

In power station practice, work is extracted from expanding steam in three stages namely High Pressure(HP), Intermediate Pressure(IP) and Low Pressure(LP) turbines. During the expansion process in the LP turbine, the steam cools down and at some stages, it nucleates to become a two-phase mixture. It is well-acknowledged in the literature that the nucleating and wet stages in steam turbines are ...

Steam Turbine Steam System