Flow along Tool-Chip Interface in Orthogonal Metal Cutting
نویسندگان
چکیده
منابع مشابه
Effect of cutting parameters on tool-chip interface temperature in an orthogonal turning process
The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...
متن کاملشبیهسازی المان محدود فرایند برش متعامد و تعیین ضخامت لایه چسبنده به ابزار در ناحیه دوم برش
The built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. The built up layer (BUL) is formed in second deformation zone near the tool-chip interface in the back of the chip. This parameter influences the tool life and machined surface quality. This BUL should not be confused with the built up edge (BUE). The deformation of the BUL in...
متن کاملInfluence of Water Cooling on Orthogonal Cutting Process of Ti-6Al-4V Using Smooth-Particle Hydrodynamics Method
Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were...
متن کاملAnalysis of Orthogonal Metal Cutting Processes
The orthogonal metal cutting process for a controlled contact tool is simulated using a limit analysis theorem. The basic principles are stated in the form of a primal optimization problem with an objective function subjected to constraints of the equilibrium equation, its static boundary conditions and a constitutive inequality. An Eulerian reference co-ordinate is used to describe the steady ...
متن کاملPrediction of tool-chip contact length using a new slip-line solution for orthogonal cutting
Tool–chip contact length is an important parameter in machining. Several ways had been proposed in different works to find its value, which gave discordant results for the same set of cutting conditions. In this paper, a new slip-line solution for orthogonal cutting by a tool with unrestricted rake face is suggested. Based on the proposed solution, a new formula for tool–chip contact length has...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Mechanical Engineering Science
سال: 1966
ISSN: 0022-2542,2058-3389
DOI: 10.1243/jmes_jour_1966_008_007_02