FLAT SYSTEM TRUSS WITH HIGH STRENGTH STEEL BUCKLING-RESTRAINED MEMBERS AS REDUNDANT STRUCTURE

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

An Experimental Study on Seismic Performance of Steel Truss Coupling Beams with Buckling-restrained Brace

Through the pseudo-static test on the steel truss coupling beams with buckling-restrained brace, the bearing capacity, deformation capacity, hysteresis curve, skeleton curve, ductility, Energy Dissipation and stiffness degradation of such coupling beam are understood. The test results show that the steel truss coupling beams with buckling-restrained brace is characterized by bigger bearing capa...

متن کامل

Local and Distortional Buckling of Cold-Formed Steel Members

Laminar structures have a high post-buckling strength reserve. Cold-formed steel profiles can be taken as a set of thin plate elements. Therefore it is necessary to design this type of profiles taking into account that reserve of strength in post-local buckling modes of failure. The method normally used to design this type of structures is based on the Effective Width concept. The Effective Wid...

متن کامل

Estimation of Hysteretic Damping in Steel Dual Systems with Buckling Restrained Brace and Moment Resisting Frame

Abstract—Nowadays, energy dissipation devices are commonly used in structures. High rate of energy absorption during earthquakes is the benefit of using such devices, which results in damage reduction of structural elements, specifically columns. The hysteretic damping capacity of energy dissipation devices is the key point that it may adversely make analysis and design process complicated. Thi...

متن کامل

Bond of High Strength Concrete with High Strength Reinforcing Steel

This paper presents a study about the bond of high strength concrete with high strength steel. Fourteen pull out tests were carried out to determine the bond. The concrete strength was about 70 MPa and the steel was a 500 MPa grade. Bar diameters used were 12, 16, 20, 25, 28, 32 and 36 mm. In order to investigate the effect of cover, each test was done twice, once in a 240 mm diameter concrete ...

متن کامل

Experimental Investigation on Seismic Behavior of Steel Truss-RC Column Hybrid Structure with Steel Diagonal Braces

This paper aims to provide an experimental support on seismic performance evaluation of the steel braced truss-RC (reinforced concrete) column hybrid structure, which could be applied as the air-cooled supporting structural system in large-capacity thermal power plants located in strong earthquake prone regions. A series of pseudo-dynamic tests (PDTs) and quasi-static tests (QSTs) were performe...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)

سال: 2004

ISSN: 1340-4202,1881-8153

DOI: 10.3130/aijs.69.85_3