Flat diamond sliding burnishing surface roughness investigation
نویسندگان
چکیده
The sliding diamond burnishing process is one among many post-machining processes applied for surface integrity enhancement purposes. This experimental study aims to investigate the effect of parameters on roughness product. Taguchi design was used, and machining considered were force, feed rate, number passes with three levels each. C45 steel alloy workpieces face milled same variables their measured before after process. Enhanced achieved increasing force minimum rate higher passes.
منابع مشابه
Experimental Investigation of the Influence of Burnishing Parameters on Surface Roughness and Hardness of Brass Alloy
Nanoparticles of iron oxide (Fe3O4) were obtained by Coprecipitation with synthesis time of 30, 60 and 90 min. The morphology of the samples was investigated by scanning electron microscopy (SEM) and structural characteristics were obtained by X-ray diffraction (XRD). The crystallite size was calculated from the spectrum X-ray diffraction with the application of the Scherrer equation and Winfit...
متن کاملAnalysis of Surface Roughness and Micro-hardness in Roller Burnishing of Aluminum Alloy 6061
Burnishing is a chip-less finishing process, in which a hard roller or ball presses the surface layer of part to perform plastic deformation in the surface layer and produce improved finish, enhanced hardness and compressive residual stresses on the surface of special materials such as Aluminum and Brass. In the following research, the effect of input parameters such as feed rate, cutting speed...
متن کاملInvestigation of surface roughness of composite fillings.
Various grinders (diamond and carbide burs, and soflex disks) were used in polishing the composite filling surfaces. Polishing was carried out 10 minutes and 14 days after the material polymerization. The ground surface was then observed by a scanning electron microscope and the surface roughness expressed in [xm. Better surface polish and lower de gree of roughness were observed when polishin...
متن کاملDetermination of Surface Roughness by Ball Burnishing Process Using Factorial Techniques
Burnishing is a method of finishing and hardening machined parts by plastic deformation of the surface. Experimental work based on central composite second order rotatable design has been carried out on a lathe machine to establish the effects of ball burnishing parameters on the surface roughness of brass material. Analysis of the results by the analysis of variance technique and the F-test sh...
متن کاملInfluence of Deep Cold Rolling and Low Plasticity Burnishing on Surface Hardness and Surface Roughness of AISI 4140 Steel
Deep cold rolling (DCR) and low plasticity burnishing (LPB) process are cold working processes, which easily produce a smooth and work-hardened surface by plastic deformation of surface irregularities. The present study focuses on the surface roughness and surface hardness aspects of AISI 4140 work material, using fractional factorial design of experiments. The assessment of the surface integri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Multidiszciplináris tudományok
سال: 2022
ISSN: ['2062-9737']
DOI: https://doi.org/10.35925/j.multi.2022.3.17