Finite Element Simulation of Flow Through Minimum Energy Loss Culverts
نویسندگان
چکیده
منابع مشابه
Finite Element Simulation of Welding Distortion in Large Structure
Fusion welding is widely used in heavy industries to join different parts together. But sometimes welding-induced distortions cause problems like misalignment during assembling and make costs to remove them. Thus it is imperative to predict and mitigate them to improve weldments quality and also reduce in fabrication costs. This study at first will introduce inherent deformation method for pred...
متن کاملFinite Element Simulation and Error Estimation of Polymer Melt Flow
Accuracy analysis is fundamental to ascertain the reliability of a numerical solution of any industrial operation. The analysis is often complex due to different error sources. In this work, two strategies to assess the discretization errors is discussed: (i) Richardson extrapolation and (ii) a posteriori error estimation based on projecting/smoothing techniques. The former utilises three neste...
متن کاملNumerical simulation of powder flow by Finite Element methods
In contrast to most fluids, flowing powders do not exhibit viscosity such that a Newtonian rheology cannot accurately describe granular flow. Assuming that the material is incompressible, dry, cohesionless, and perfectly rigid-plastic, generalized Navier-Stokes equations (’Schaeffer Model’) have been derived where the velocity gradient has been replaced by the shear rate, and the viscosity depe...
متن کاملFinite Element Methods for the Simulation of Incompressible Powder Flow
Abstract. The flowing of powders brings a new challenging and interesting problem to the CFD community: at very high concentrations and low rate-of-strain, grains are in permanent contact, rolling on each other. Therefore a frictional stress model must be taken into account. This can be done using plasticity and similar theories in which the granular material behaviour is assumed to be independ...
متن کاملAdaptive finite element simulation of Stokes flow in porous media
The Stokes problem describes flow of an incompressible constant-viscosity fluid when the Reynolds number is small so that inertial and transient-time effects are negligible. The numerical solution of the Stokes problem requires special care, since classical finite element discretization schemes, such as piecewise linear interpolation for both the velocity and the pressure, fail to perform. Even...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Trends in Applied Sciences Research
سال: 2007
ISSN: 1819-3579
DOI: 10.3923/tasr.2007.535.539