Finite Element Simulation Analysis of Central Pull-out Experiment of Steel Bar and Recycled Concrete
نویسندگان
چکیده
In order to study the bond performance of steel bars and recycled concrete, ultimate stress distribution between concrete is analyzed through central pull-out test, influence grooving on actual considered. Therefore, in this paper uses finite element software ABAQUS used simulate test discuss force concrete. The results show that simulation analysis experiment are good agreement with experimental results, which verifies accuracy model.
منابع مشابه
Analysis of Thin-Walled Steel Sections Filled with Concrete Using Non-Linear Finite Element Method
Being economical and performing well under cyclic loads, steel sections filled with concrete have been widely used in structural buildings. Extensive studies and experiments have been conducted to investigate the influence of different parameters and loadings on the behavior of these structural components. Based on the data available from previous experiments and studies, this paper discusses t...
متن کاملAnalysis of Thin-Walled Steel Sections Filled with Concrete Using Non-Linear Finite Element Method
Being economical and performing well under cyclic loads, steel sections filled with concrete have been widely used in structural buildings. Extensive studies and experiments have been conducted to investigate the influence of different parameters and loadings on the behavior of these structural components. Based on the data available from previous experiments and studies, this paper discusses t...
متن کاملAnalysis of Roll Wear in Reshaping Using Finite Element Simulation
Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...
متن کاملFinite Element Analysis of Hardened Steel Cutting
Hard machining, as attractive replacement for many rough and finish grinding operation, generates high cutting forces and temperature that enhance tool wear when act together. Therefore, the tool geometry and machining parameters have to be carefully optimized for a given material. Because of high cost and time consuming experimental work up-to-date advanced software for modeling and simulation...
متن کاملNon - linear finite - element analysis of punching capacities of steel – concrete bridge deck slabs
j1 Yu Zheng MEng, PhD Associate Professor, Department of Civil Engineering, Dongguan University of Technology, Dongguan, PR China j2 Des Robinson PhD, MRAeS Senior Lecturer, School of Planning, Architecture and Civil Engineering, Queen’s University of Belfast, Belfast, UK j3 Su Taylor PhD, MICE Reader in Structural Engineering, School of Planning, Architecture and Civil Engineering, Queen’s Uni...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Engineering Research and Reports
سال: 2023
ISSN: ['2582-2926']
DOI: https://doi.org/10.9734/jerr/2023/v24i11851