Finite element modeling of melt pool dynamics in laser powder bed fusion of 316L stainless steel

Effects of powder recycling on stainless steel powder and built material properties in metal powder bed fusion processes

Measurement of the Melt Pool Length during Single Scan Tracks in a Commercial Laser Powder Bed Fusion Process

Contact author: [email protected] Certain commercial equipment, instruments, or materials are identified in this paper in order to specify the experimental procedure adequately. Such identification is not intended to imply recommendation or endorsement by the National Institute of Standards and Technology, nor is it intended to imply that the materials or equipment identified are necessari...

Using Design of Experiments in Finite Element Modeling to Identify Critical Variables for Laser Powder Bed Fusion

Input of accurate material and simulation parameters is critical for accurate predictions in Laser Powder Bed Fusion (L-PBF) Finite Element Analysis (FEA). It is challenging and resource consuming to run experiments that measure and control all possible material properties and process parameters. In this research, we developed a 3-dimensional thermal L-PBF FEA model for a single track laser sca...

Experimental and 3D Finite Element Studies of CW Laser Forming of Thin Stainless Steel Sheets

Laser forming as a springback-free and noncontact forming technique has been under active investigation over the last decade. Previous investigations are mainly focused on forming of large and thick workpieces using high power lasers, with less work on precision, micro-scale bending of small and thin sheets. In this work, a 4 W continuous wave argon ion laser is used as the energy source, and t...

Electrochemical polishing of 316L stainless steel slotted tube coronary stents.

Surface smoothness is one of the properties determining the performance of stents. Therefore, surface polishing shows its importance in the exploitation and production of stents. The present study explores electrochemical polishing of 316L stainless steel slotted tube coronary stents produced by laser cutting. Acid pickling was also studied as a pre-treatment of electrochemical polishing of the...