Finite Element Modeling and Validation of Chip Segmentation in Machining of AISI 1045 Steel
نویسندگان
چکیده
منابع مشابه
Finite Element Method Simulation of Machining of AISI 1045 Steel With A Round Edge Cutting Tool
In this paper, FEM modeling and simulation of orthogonal cutting of AISI 1045 steel is studied by using dynamics explicit Arbirary Lagrangian Eulerian method. The simulation model utilizes the advantages offered by ALE method in simulating plastic flow around the round edge of the cutting tool and eliminates the need for chip separation criteria. JohnsonCook work material model is used for elas...
متن کاملFinite Element Simulation and Experiment of Chip Formation Process during High Speed Machining of AISI 1045 Hardened Steel
As an advanced manufacturing technology which has been developed rapidly in recent years, high speed machining is widely applied in many industries. The chip formation during high speed machining is a complicated material deformation and removing process. In research area of high speed machining, the prediction of chip morphology is a hot and difficult topic. A finite element method based on th...
متن کاملExpansion and fracture of AISI 1045 steel explosive-filled cylinders
By a improved front light-source framing photography technique and a simple fragments soft recovered method, the expansion and fracture behaviour of the AISI 1045 steel cylinders loaded by three different brisance explosives have been studied . Cylinders were heat treated-normalized and quenched and tempered. Experimental results show that the more intensive of the loading ,the stronger capabil...
متن کاملAn Investigation into the Microstructure of Adiabatic Shear Banding in AISI 1045 Hardened Steel due to High Speed Machining C.Z.Duan
Adiabatic shear banding during high speed machining is important to understand material removal mechanisms. This paper investigates the microstructure of adiabatic shear bands (ASBs) in the serrated chips produced during the high speed machining of AISI 1045 hardened steel. Optical microscope, scanning electronic microscope(SEM) and transmission electronic microscope(TEM) were used to explore t...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2017
ISSN: 2212-8271
DOI: 10.1016/j.procir.2017.03.259