Finite Element Method Based Modeling for Tool Wear Prediction in Orthogonal Cutting Process
نویسندگان
چکیده
منابع مشابه
Evaluation of Disc Cutter Performance in Rock Cutting Process Using 3D Finite Element Method
Today, numerical simulation can be used as a suitable tool to measure large quantities that are very expensive and, in some cases, impossible to measure. One of the important issues in predicting rock mass boreability in excavation with full face tunnel boring machines is estimating the discchr('39')s forces for rock cutting. For this purpose, the linear cutting test is employed. However, limi...
متن کاملthe effect of tool rake angle and cutting speed on cutting force during broaching process by using finite element modeling
0
متن کاملFinite element modeling of erosive wear
Material damage caused by the attack of particles entrained in a fluid system impacting a surface at high speed is called ‘Erosion’. Erosion is a phenomenon that takes place in several engineering applications. It also can be used in several manufacturing process such as abrasive waterjet machining. Erosion is a complex process dependent on particle speed, size, angle of attack as well as the b...
متن کاملThe Analysis and Simulation for Improved Cutting Process based on Finite Element Method (FEM) Analysis
The paper proposed the practical metal cutting process using FEM to simulate the traditional cutting process, the simulation and the analysis of the results are based on the support of DEFORM3D finite element software, and the characteristic between Galerkin Algorithm and FEM analysis is also analyzed. Then the paper processed the modeling procedure for FEM using Lagrange and Euler algorithm, t...
متن کاملA Proposed Modeling Method in Finite Element Slope Stability Analysis
Limit-equilibrium method (LEM) and finite element method (FEM) with strength reduction method (SRM) techniques are the most widely used analysis tools in slope stability assessment. Recently, researchers have reported that both factor of safety (FOS) values and failure surfaces obtained from LEM and FEM are generally in good agreement, except in some particular cases. In this paper, the FOS and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Conference on Aerospace Sciences and Aviation Technology
سال: 2017
ISSN: 2636-364X
DOI: 10.21608/asat.2017.22380