Finite-element-based moisture transport model for wood including free water above the fiber saturation point
نویسندگان
چکیده
منابع مشابه
Dynamic Analysis of Carbon Fiber-Reinforced Wood Composites Based on Finite Element Model
Carbon fibers were pretreated by ultrasonic agitation and then were used to manufacture carbon fiber-reinforced wood composites (CFRWCs). The modulus of rupture (MOR) and the modulus of elasticity (MOE) for the CFRWCs were measured. The effects of the compounding pattern and proportion of carbon fiber on the dynamic performance were investigated by dynamic thermomechanical analysis (DMA) and fi...
متن کاملSurface Colour Change in Wood during Drying above and below Fibre Saturation Point
A technique, useful for studying the formation of kiln brown stain in wood drying, has been developed to measure the surface colour change in a single board wood sample during drying. The wood sample is planed carefully in the green state to remove any surface wood that was damaged during cutting. The intact tracheids at the surface cause the evaporative front to remain at the surface during dr...
متن کاملSaturation estimates for hp-finite element methods
In this paper we will prove saturation estimates for the adaptive hp-finite element method for linear, second order partial differential equations. More specifically we will consider a sequence of nested finite element discretizations where we allow for both, local mesh refinement and locally increasing the polynomial order. We will prove that the energy norm of the error on the finer level can...
متن کاملFinite element simulation of two-point incremental forming of free-form parts
Two-point incremental forming method is considered a modern technique for manufacturing shell parts. The presence of bottom punch during the process makes this technique far more complex than its conventional counterpart i.e. single-point incremental forming method. Thus, the numerical simulation of this method is an essential task, which leads to the reduction of trial/error costs, predicts th...
متن کاملA NEW APPROACH BASED ON FINITE ELEMENT MODEL UPDATING FOR STRUCTURAL DAMAGE IDENTIFICATION
In this study, the finite element model updating was simulated by reducing the stiffness of the members. Due to lack of access to the experimental results, the data obtained from an analytical model were used in the proposed structural damage scenarios. The updating parameters for the studied structures were defined as a reduction coefficient applied to the stiffness of the members. Parameter v...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Heat and Mass Transfer
سال: 2020
ISSN: 0017-9310
DOI: 10.1016/j.ijheatmasstransfer.2020.120228