Finite Element Analysis of Slope Treatment Scheme in Eastern Fuling River
نویسندگان
چکیده
منابع مشابه
A Proposed Modeling Method in Finite Element Slope Stability Analysis
Limit-equilibrium method (LEM) and finite element method (FEM) with strength reduction method (SRM) techniques are the most widely used analysis tools in slope stability assessment. Recently, researchers have reported that both factor of safety (FOS) values and failure surfaces obtained from LEM and FEM are generally in good agreement, except in some particular cases. In this paper, the FOS and...
متن کاملAnalysis of Roll Wear in Reshaping Using Finite Element Simulation
Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...
متن کاملFinite Element Analysis of Safety Mechanism in a Mechanical Controller
In this study, dynamic behavior of safety mechanism of a mechanical controller is investigated using 3D-FE simulation. This paper is concentrated on controller of a high acceleration projectile. The controller is located in the top of the projectile. Safety mechanism is divided to deformable and rigid parts. Deformable and rigid parts are simulated in Abaqus and Adams commercial soft wares; res...
متن کاملAppropriate Loading Techniques in Finite Element Analysis of Underground Structures
Stability of underground structures is assessed by comparing rock strength with induced stresses resulted from ground stresses. Rock mass surrounding the opening may fail either by fracture or excessive deformation caused. Accurate calculation of induced stresses is therefore fundamental in the stability analysis of an opening. Although numerical methods, particularly finite element method, are...
متن کاملFracture Mechanics Analysis of Fourth Lumbar Vertebra in Method of Finite Element Analysis
Objective: In this paper, finite element model of the L4 vertebra subjected to combination of compression and flexion loading in isotropic and anisotropic cases is investigated. Methods: In both cases, the vertebra is considered homogeneous. Also, the body of vertebra is divided to cancellous and cortical sections in anisotropic model, but the process is assumed isotropic such as isotropic mode...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Hans Journal of Civil Engineering
سال: 2017
ISSN: 2326-3458,2326-3466
DOI: 10.12677/hjce.2017.66072