Finite Element Analysis of HASTELLOY C-22HS in End Milling
نویسندگان
چکیده
منابع مشابه
Finite Element Analysis of Hastelloy C-22hs in End Milling
This paper presents the finite element analysis to study the stress distribution of nickel based superalloy HASTELLOY C-2000 in end milling operation. A commercial finite element software was used to develop modeling and analysis the distribution of stress components in the machined surface after end milling of HASTELLOY C-22HS using coated carbide tools. The friction interaction along the tool...
متن کاملComparing up and Down Milling Modes of End-Milling Using Temporal Finite Element Analysis
Two types of end milling at partial radial immersion are distinguished in this work, namely; up and down end-milling. They are theoretically given comparative study for a three tooth end miller operating at 0.5, 0.75 and 0.8 radial immersions. 0.5 and 0.8 radial immersion conditions are chosen so that analysis covers situations in which repeat and continuous tool engagements occur while 0.75 ra...
متن کاملThe Performance of an Hexahedron C* Element in Finite Element Analysis
The performance of an 8-noded hexahedron C1* element in elasticity is investigated. Three translational displacements and their derivatives as strain in each direction are considered as degrees of freedom (d.o.f.’s) at each node. The geometric mapping is enforced using a C0 element with no derivative as nodal d.o.f.’s . The stiffness matrix of the element is also computed using a transformation...
متن کاملAnalysis of Roll Wear in Reshaping Using Finite Element Simulation
Reshaping process is a widely used method for producing tubes with non-circular cross sections. Owing to the friction between pipe and rolls, initial round pipe moves forward and consequently, it gradually formed into square or rectangular one. In practice, geometric profile of the rolls will be changed after a while. These changes would be detrimental the production of faultless products. Ther...
متن کاملFinite Element Analysis of Safety Mechanism in a Mechanical Controller
In this study, dynamic behavior of safety mechanism of a mechanical controller is investigated using 3D-FE simulation. This paper is concentrated on controller of a high acceleration projectile. The controller is located in the top of the projectile. Safety mechanism is divided to deformable and rigid parts. Deformable and rigid parts are simulated in Abaqus and Adams commercial soft wares; res...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF MECHANICAL ENGINEERING AND SCIENCES
سال: 2011
ISSN: 2289-4659,2231-8380
DOI: 10.15282/jmes.1.2011.4.0004