Finite Element Analysis (FEA) on Autonomous Unmanned Surface Vehicle Feeder Boat subjected to Static Loads
نویسندگان
چکیده
منابع مشابه
Finite Element Analysis of Aluminum Honeycombs Subjected to Dynamic Indentation and Compression Loads
The mechanical behavior of aluminum hexagonal honeycombs subjected to out-of-plane dynamic indentation and compression loads has been investigated numerically using ANSYS/LS-DYNA in this paper. The finite element (FE) models have been verified by previous experimental results in terms of deformation pattern, stress-strain curve, and energy dissipation. The verified FE models have then been used...
متن کاملUsing Finite Element Method Vibration Analysis of Frame Structure Subjected to Moving Loads
It was purposed to understand the dynamic response of frame which are subjected to moving point loads. The finite element method and numerical time integration method (New mark method) are employed in the vibration analysis. The effect of the speed of the moving load on the dynamic magnification factor which is defined as the ratio of the maximum dynamic displacement at the corresponding node i...
متن کاملAutonomous Landing Unmanned Aerial Vehicle
This thesis presents the system architecture for landing an Unmanned Aerial Vehicle (UAV) from a hovering position without the intervention of a human operator. Through the use of feedback information from a height sensor, the UAV is commanded to perform controlled descent with the desired landing parameters by implementation of the flight control laws. The plant model of the system was determi...
متن کاملFinite Element Analysis of Permanent Magnet Synchronous Motors Subjected to Symmetrical Voltage Sags
This paper studies the effects of symmetrical voltage sags on the operational characteristics of a Permanent Magnet Synchronous Motor (PMSM) by Finite Element Method (FEM). Voltage sags may cause high torque pulsations which can damage the shaft or equipment connected to the motor. By recognizing the critical voltage sags, sags that produce hazardous torque variations could be prevented. Simula...
متن کاملFinite Element Analysis of Buckling of Thin Cylindrical Shell Subjected to Uniform External Pressure
One of the common failure modes of thin cylindrical shell subjected external pressure is buckling. The buckling pressure of these shell structures are dominantly affected by the geometrical imperfections present in the cylindrical shell which are very difficult to alleviate during manufacturing process. In this work, only three types of geometrical imperfection patterns are considered namely (a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Structural Integrity
سال: 2020
ISSN: 2452-3216
DOI: 10.1016/j.prostr.2020.07.022